About this deal
Wipe with silicon oil. If problem persists, it may be due to deterioration of O-ring replace→with new parts ooking into the muzzle is extremely dangerous regardless of BBs having been loaded or not. If you get hit in the eye by a BB pellet, you may in worst case, lose your eye sight. The question widely asked of us is "How do I increase the rate of fire?", even on guns that are already putting BBs out in a solid stream - go figure... Wait until the pistol is at normal room temperature. Ensure magazine is full. Add silicon oil on nozzle rubber Replace defective parts (may also be due to faulty safety mechanism or worn/dirty parts in the impact system
All FPS is listed based on the use of a standard 0.20g BB when first tested and all listed FPS are +/- 5% due to differences from weapon to weapon. If you require a guaranteed FPS, please add an upgrade/downgrade option on to your product (this may cost extra) - Electric Guns Only.Should NOT be used indoors or in confined spaces (inside bunkers or similar) due to the blast/debris and high sound level. If misused these WILL injure or cause permanent damage to hearing. Not available for out of area destinations; Highlands and Islands, Isle of Man, Northern Ireland, Isle of Wight Any figures used are based on tests performed on the products when they are first listed. These can vary due to changes by the manufacturer, gas pressure, gas used and a number of other factors. All figures should be treated as an approximate guide and used for reference only. Snake-Tone is a smooth finish and due to the way it is sprayed, it may not be confined to just the upper part of the weapon E.g. It may encroach on the lower frame, grip etc. Well this can be done easily with the change to a higher voltage battery or with a more technical approach, which can range from a less powerful spring -which reduces your F.P.S.- to the more elaborate use of the prototype sector gear that gives two piston strokes per revolution.Throw into this mix a high speed motor and what is the result? "Aha" you say "mind boggling BB carnage"---Wrong
We cannot offer an exchange on pyrotechnic devices due to device failure or items that have been stored for long periods of time. We are unable to guarantee that the pyrotechnic device has been stored in a moisture free environment or used correctly in accordance with the manufacturers guidelines. Zombie/Alien Blood finishes are not sprayed and are therefore not smooth finishes. These are supposed to look like 'congealed blood' across the weapon. If slide stops in the middle, there may be a piston o-ring blown into the cylinder. Remove and replace with new piston ring
TRIP WIRE ALARMS
Overcharging your battery will ruin your battery so that it won't hold a charge. Remember to never overcharge your battery! For a more accurate estimate, take the mAh listed on the battery, the mAh of the output listed on your charger and use the following formula: May be due to foreign matter, deformity of magazine output lips, poor BB pellets. Remove foreign matter/replace parts as required