Yonico 14705 1/2-Inch Height with 6 Bearings Rabbet Router Bit & Bearing Set 1/2-Inch Shank

Product Information

The rabbeting cutter is a very versatile router bit which can be used to cut a variety of different wood joints. The cutting depth (c/d) of the bit can be varied by changing out the ball bearing guide for different size bearings. Contributing editor Steve Latta teaches cabinetmaking at Thaddeus Stevens College in Lancaster, Pa. But it’s just a rabbet!” my students sometimes complain. Why overthink it? After all, most folks follow the standard protocol: on the tablesaw with a dado head buried in a sacrificial fence. However, the first approach is not necessarily the best. While there’s no doubt the tablesaw works, there are factors that might encourage an alternative method. The key question is, what matters more: what’s removed, or what remains? Two ways to cut a rabbet Become an UNLIMITED member and get it all: searchable online archive of every issue, how-to videos, Complete Illustrated Guide to Woodworking digital series, print magazine, e-newsletter, and more. Synopsis: Decide what’s more important — the tongue or the shoulder — and you will know the best method to use for cutting a particular rabbet. Despite the simplicity of the joint, it’s not as cut and dried as it seems. Sometimes a tablesaw and dado blade is the best method; other times, you’ll want to turn to the router table.

The Whiteside multi rabbeting router bit set provides 8 different bearings and therefore 8 different cutting depths, including flush trim. The set includes 2 bushings for the 2 larger bearings and a hex key wrench too. For the router-table method to be both safe and successful, you must use the proper bit. Although a rabbeting bit seems logical, most are not designed for this application. On most rabbeting bits, the carbide cutter extends proud only on the top and has relief angles ground in the carbide to reduce burning. The bottom of the bit is often an afterthought, with the main body sometimes extending below the actual cutter. Some have a shear cut which, although beneficial when cutting from below, impedes the cut if used above since it directs chips to the base of the cut, which is exactly where you don’t want them to be. Also, many rabbeting bits do not have a long enough shank for the cutter to get to the proper height without seriously compromising how much of the bit is in the collet. Use slot-cutting bits You don't have permission to access "http://www.homedepot.com/p/Yonico-Rabbet-with-6-Bearing-1-4-in-Shank-Carbide-Tipped-Router-Bit-14705q/304970771" on this server.