Joined in 2023 
82 
63 About this deal
After adjusting the position of the rear plate, you can still use the focal length setting bar to set the position of the laser module. Now we’ll Frame our letter T and that will send the laser head to where the T is located in the workspace. Right at this moment we don’t care where that location is. We just want to test our machine. The D1 Pro is a Class 4 laser that can damage your eyes and burn skin. It also produces smoke and fumes while engraving or cutting materials. You must take precautions to operate the machine safely. Use this and any other laser at your own risk. Align the middle plate with the screw holes on the sliders, and use screws to hold the middle plate and sliders together. Engraving & Cutting Compatibility: Wood, bamboo, cloth, cork, plastic, and more Engraving-specific Compatibility: Fiberglass, stainless steel, titanium alloy, and moreSee tech specs for full list
Put the shaft through the coupling, and then put it through the timing belt and insert it into the idler pulley. If you can't put the shaft through the timing belt, the possible cause is that the timing belt is set too tight. You can adjust its tension by turning the screw. For details about how to create with example projects, see “Example Project - Making a Phone Holder.” Since the laser is literally burning material, never allow it to operate unattended and have a fire extinguisher handy just in case. Safety is a major concern when operating laser devices. xTool has included a transparent shield attached to the laser module to prevent you from looking directly at the laser beam. You should still wear safety glasses (included) when operating the laser without a cover.For details about how to use LightBurn to operate xTool D1 Pro, see " Operate xTool D1 Pro with LightBurn ." The air assist blows cool air onto your work surface, which prevents charring while also keeping the smoke from gunking up the laser lens. The results are cleaner cuts, less charred looking engraving and a safer experience. The air pump and tubing are much like those seen on a fish tank or airbrush, and just as noisy. When the light shield is dirty or laser beams can't cut a material, you need to clean the laser module. This is an open-frame device and only comes with a small sheet of metal to protect your work surface. XTool also makes a honeycomb work panel specifically for diode lasers that protect your table while also preventing your pieces from becoming charred.
When you hit the Framing button it will instruct you to push the button on top of your xTool D1 Pro. Then the framing operation will begin. You can do this as many times as you need to.Before creating your works, you can place the aluminum sheet in the working area of xTool D1 Pro to protect your desk or floor from being smoked or burned. After looking at the insulated cup, I'm doubtful this would fit my needs for precision-cutting small batches of sheet aluminum. The air assist and honeycomb bed are *ESSENTIAL* for most jobs, especially when it comes to cutting. If you want a professional finish without the charred look, you need to be running an air assist module and the honeycomb base, there is are little to no projects that work better without them. Insert the connectors into the port on the main control board and the one on the motor, respectively. Some materials should not be burned with a laser due to their chemical makeup – they could melt, catch fire or produce toxic fumes. Dallas Maker Space has published a list of safe and hazardous materials to use with their laser. The list of no-nos includes plastics, fiberglass and certain foams.
Great Deal 
New Comment