SFA, Sani Broy Pro Toilet seat Lifting System, White, 0014

Product Information

Remove the toilet and look inside the pan connector to see if the Turboflush is full of toilet paper, if so read below. There is always 2-3 inches of water left in the bottom of a Saniflo after use, this is where the the human waste and limescale forms. Normally this is bad news, the reason for this type of problem is a worn or faulty motor as water is getting in to the electrics and fusing the circuit. Sometimes but in rare cases you may have loose wiring where the Saniflo is connected but is very rare its normally a dead Saniflo, you will have to buy a new unit as the motor is unrepairable. Plan B, put a plug on the macerator and plug it in to a different circuit using and RCD Adapter for safety and see if the machine works, if not it is most likely time for a new macerator pump

If your Sanitop is not turning off, it could be due to electrical issues. This could include a faulty circuit board, damaged wiring, or a malfunctioning motor or damaged microswitch. These issues can prevent the unit from shutting off when it’s supposed to, leading to increased energy consumption and potential damage to the system. 4. Water Pressure Issues If your Saniflo is activating repeatedly non stop the Saniflo non return valve is most likely defective and needs cleaning or replacing. On the newer model of Saniflo its an easy job to do it’s located on top of the machine and can be pulled out by undoing the jubilee clip. If your Saniflo is one of the older models the non return valve is located inside of the machine and the macerator will need to be removed to get access.Here are 5 good reasons why you should always choose a Saniflo approved engineer for Saniflo repairs and service.

Compliance with regulations: A non-return valve is necessary to meet plumbing regulations and standards, ensuring your Sanitop system is safe and legal to install. The majority of our engineers have between 10 and 20 years experience working with the Saniflo range and will have encountered Sometimes if the rubber on the Sanitop macerator non return doesn’t have limescale damage and is not sealing could be the rubber has been damaged either by a foreign object or the rubber has been damaged by chemicals and the rubber valve has enlarged or is distorted. Easy Product Identification: Finding the right spare parts is hassle-free with our product ID system. Simply enter the product ID to view all compatible parts and accessories for your specific Saniflo system.Our engineers carry spares for most of our range, including many of the early models. If the engineer does not There are a few reasons for this type of problem, you could have a faulty Saniflo microswitch, a faulty Saniflo membrane or water is getting in to the Saniflo from a dripping tap, overflowing toilet, a condensing boiler may be connected to it. More Saniflo Problems Troubleshooting FAQ Solutions When it is quite dirty in the bottom as the Saniflo fills with water, the air is pushed out of the Saniflo air vent this is where the fouls smells come from.