Gyproc Plasterboard Patches various sizes 12 Pack (2 x 50mm, 5 x 100mm & 5 x 150mm))

Product Information

There are many different fillers and plaster products available, so be sure to consider the range and select a product that is best suited to your job. For example, if you only need a small amount, you might find it easier to use ready mixed plaster As you will need to do a bit of cutting, before you start this, firstly run over the area around the hole with a wire detector to make sure there aren’t any wires, pipes or other items that you may accidentally cut through. Picture the scenario. You have a job list as long as your arm, but you’re seeking efficient solutions for your customers, saving you time but not cutting corners. To repair a hole in a hollow door, wall, or ceiling, firstly trim the edges of the hole and make is square. Ironically, you actually have to make the hole larger before you can go about fixing it!

Once the patch is dry and firmly in position, gently remove the screw. Use patching plaster, all purpose filler or multi-finish plaster — mix up enough to cover the patch and gently press into the hole and spread with a putty knife that is larger than the hole to help get a smooth finish. Gyproc EasiFill 20 has a working time of 20 minutes and the second coat can be applied after 40 minutes. Gyproc EasiFill 45 has a working time of 45 minutes and the second coat can be applied after 80 minutes. Now draw two lines across the gap to create a rectangle around the hole. Cut out the existing plasterboard with a sharp Stanley knife or use a small jab saw. Due to the nature of plasterboard and in a similar way hollow doors, they can become damaged quite easily.

Thorough preparation is key to achieving a high-quality finish, so be sure to remove all traces of old plaster, dust and grease for the area you plan to repair Once dry, you can gently rub down the plaster or filler, and then paint the repaired area to match the surrounding wall. How to Fill Large Holes in Plasterboard

Measure and cut a new piece of plasterboard to fill the hole. Fix in place with plasterboard screws or nails. Mix up plaster, apply and leave to dry. Once the adhesive has dried enough to support the patch you can now push the screw out into the wall void. Leave for a further 24 hours for the adhesive to completely harden off and then you can start filling.Now you need to measure and cut two noggins (horizontal wood that bridges the gap between the studs). Use a bit of 2 x 4 inch – approximately 100mm x 50mm – timber to create the noggins. Nail or screw them into position, between the studs, from the sides. This will create an area to fix your new plasterboard patch to. Apply the filler by working it into the holes of the patch and towards the edge. Feather out at least 50mm beyond the edges of the patch to create a smooth, seamless finish. Leave to set for a minimum 30 minutes.