Mapei Ultracolor Plus Coloured Grout Moon White 103

Product Information

All Mapei Ultracolor Plus grout colours are also available in a matching silicone – Mapesil AC Silicone. If using this grout with moisture sensitive natural stone tiles, a low modulus silicone is advised – Mapei Mapesil LM Silicone. excellent workability, much better than traditional epoxy mortars thanks to its creamy consistency, which guarantees smooth and compact surface finish which is non-absorbent and easy to clean; it guarantees a high level of hygiene, Before grouting, make sure the installation mortar or adhesive has set and that most of the moisture has evaporated. Mapei Fuga Fresca is designed to be the perfect product for giving old and stained grout that new look finish. The Fuga comes in a small, blue handheld, shoe polish style case with a foam applicator end. A shake and a squeeze will fill the foam end with the Fuga paint ready for application.

Smooth and compact surface finish which is non-absorbent and easy to clean; it guarantees a high level of hygiene, where a high protection from the formation and proliferation of micro-organisms (such as fungus and mould) is required; where a high protection from the formation and proliferation of micro-organisms (such as fungus and mould) is required; obtained and pour Mapecolor Metallic in it; cover it and manually mix to properly blend the powder pigment. Then mix Repairing existing degraded grouts by removing all loose areas and to a minimum uniform depth of 3 mm.After mixing the two components as described above, spread the adhesive on the substrate using a suitable notched UltraCare Kerapoxy Cleaner can be used both immediately after grouting and after completing laying work. After the finishing operation, it is very important that no traces of Kerapoxy Easy Design remain on the tile surface. Once

Always carry out preliminary tests before grouting stone or ground porcelain with a porous or rough surface. Mixing Mapecolor Metallic with Kerapoxy Easy Design of other colours may result in numerous metallic effects with After the final cleaning operation, if the surface still has traces of Mapei Ultracolor Plus due to incorrect application, it may be cleaned down with an acidic cleaner (e.g. Keranet), by following the relevant instructions, at least 24 hours after grouting the joints. Only use Keranet on surfaces which are resistant to acid, and never use it on marble or limestone material. used for grouting. Kerapoxy Easy Design may be mixed with up to 6 % by weight of MapeGlitter, metallised coloured glitter, to create aesthetic effects. Percentage depends on the aesthetic effect and workability desired. MapeGlitter is available in silver and gold. that the joints are filled right down to the bottom. Remove excess material by passing the edge of the same trowelFor residues that have cured on the surface over time or if residues persist then use UltraCare Epoxy Off Gel, special highviscosity cleaner to remove epoxy residues. Mapei Ultracolor Plus forms a smooth, compact finished surface with optimum resistance to abrasion, compression and flexural strength, and good resistance to acids with a pH > 3. Floors are ready for light foot traffic after approx. 3 hours. Surfaces grouted with Mapei Ultracolor Plus may be put into service after 24 hours. Basins and swimming pools may be filled up 48 hours after grouting.