Liberon SDDO1L 1L Spirit Wood Dye - Dark Oak

Product Information

A. Yes you can. Our Wood Stain has been designed to deeply penetrate all wooden surfaces. However, you’ll always get best results by giving the wood a light sand first with #100 Sanding Pads.

A. If the surface is dirty clean it first with a suitable Wood Cleaner. Otherwise, sand it with #100 Sanding Pad in the direction of the grain. If the wood is freshly sawn, you may need to start with something more coarse such as 120g sandpaper and work your way up with the Sanding Pads. Light oak woods typically have a honey-coloured hue which can be enhanced and duplicated by using our Natural Oak Wood Stain. It is specially formulated to evenly stain wood and dries to a natural matt finish in only 10 minutes.

The Wood Stain instructions below explain thoroughly how to prepare wood, stain wood, and then how to protect wood afterwards. They will help you get the best results when using our Wood Stain. Preparing Wood for Staining After wiping off the excess Wood Stain, you’ll need to wait for about 10 minutes for the stain to thoroughly dry. Once it’s dry, a second coat can be applied if desired; applied in the same way as the first.

A. Wood Stain is designed to penetrate into the wood and so the longer you leave it on the more it will soak in and the darker the wood will become. Wood can also only absorb so much stain before it becomes saturated and so any excess would then dry on the surface. This is why we recommend wiping the stain off after one or two minutes. P101 If medical advice is needed, have product container or label at hand.P102 Keep out of reach of children.P210 Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.P271 Use only outdoors or in a well-ventilated area.P501 Dispose of contents/container to … After staining wood, you should finish the job by sealing the stain in with one of our Wood Waxes, Wood Varnishes or Wood Oils. These will enhance the colour of the stain further, provide additional protection and can be used to alter the finish to either satin or gloss. Wood Stain Options Apply Evenly: Whether using a brush, cloth, or applicator pad, it's essential to apply the stain evenly, following the grain of the wood. Avoid leaving puddles or uneven patches, resulting in an inconsistent finish.Before we discuss stains and finishes, it's essential to understand the inherent qualities of oak wood. If you are unsure of the wood stain colour, test it on an unseen area first. The stain can be applied with either a cloth, bristle brush, or for best results a Foam Brush. Apply the stain liberally going in the direction of the grain. Leave it to soak in for a minute or two and then wipe any excess of using a Lint Free Cloth. Used Wood - If the wood is old, it may be painted or varnished. If so, remove any old coatings using a Paint & Varnish Remover first. These coatings will prevent the Wood Stain from soaking into the wood. If the wood has been treated with an oil or wax, wipe the surface down with thinners or mineral spirit to remove this. After removing the old finish, sand smooth with #100 Fine Sanding Pad. When using a paint to colour wood, you risk hiding the natural grain. Whereas a wood stain is designed to completely soak into the wood, stain it to your chosen colour and bring out the beauty of the natural grain in the timber.