Varilight MJP120 V-Pro 2 Way Push-On Push-Off LED Replacement Dimmer Module Kit - 1 x 0-120W (1-10 LEDs)

Product Information

This V-Pro dimmer module will eliminate dimmer buzz in GLS bulbs, GU10 lamps, and LV transformers including trailing edge loads. This dimmer is also fitted with a self-resetting overload protection and a heat sensor meaning the dimmer will stop working before any damage can be caused to the unit.

way or 2 way operation. Allows dimming from 1 side of the room and switching from another. If 2 way dimming is required then see the Varilight Eclique range were a master and slave touch dimmer combination can be used. Way Push-on Push-off LED Replacement Dimmer Module Kit 1 x 0-120W (1-10 LEDs). Not suitable for use with non-dimmable fluorescent bulbs and tubes, wire-wound or toroidal transformers, TRIAC dimmable loads or electric motors. Do not overload. Indoor Use Only for Domestic lighting circuits. Varilight V-Pro LED dimmer switch module that can be used to upgrade or modify existing dimmer switches. Supplied as a dimmer module only and must be used with a separate plate switch that has the industry standard 6mm D spindle. This module will dim a variety of lighting loads including LED, CFL and halogen.Contains trailing edge V-Pro dimming technology which can be reprogrammed to emulate leading edge mode but isn't TRIAC (see V-COM for true TRIAC dimmer switch). All V-Pro dimmers offer superior dimming technology to deliver the best possible dimming performance for a given load. V-Pro dimmers are suitable for mains lighting, most dimmable electronic transformers and, with a 10W minimum load, are suitable for dimmable low energy lighting, including many dimmable LEDs.

For best results with low voltage lighting use VARILIGHT electronic transformers. There is no limit on the number of transformers you can use as long as you keep within the maximum rating of the dimmer. VARILIGHT electronic transformers are suitable for controlling 12V a.c. rated LEDs (MR16). V-Pro dimmers are not suitable for wire-wound "toroidal" transformers. This dimmer can also be used for mains incandescent GLS lamps (standard mains light bulbs), GU10 Lamps or similar Hi Spot Mains Halogen lamps, (only use quality UK supplied lamps), up to the maximum load as specified on the dimmer. The V-Pro Series Dimmers can NOT be used for wire-wound Low Voltage transformers, fans or inductive loads. If a product fails after six months of receiving the item it is considered a warranty claim and is the responsibility of the buyer to pay for the return postage. We will then dispatch a free-of-charge replacement once the original has been received and tested. Book a DPD Return Here I have used Fastlec three times each time I have found them to be efficient fast and happy to give you information on their products." The V-Pro Series Dimmers can also be used for Mains Voltage Lighting, Trailing Edge Loads, and Electronic Low Voltage Transformers.

Storage Heater Deliveries:

Scottish Highlands, areas which we class as zone 1 are post codes: AB30-38, AB44-56, FK17-99, G83, IV1-28, IV30-32, IV33-39, IV52-54, IV63, KW1-14, PA21-33, PA34-40, PH18-26, PH30, PH31-41, PH49-50 Controlled by a micro-processor, V-Pro dimmers offer sophisticated overload protection. This means that if you mistakenly connect your dimmer to too many lights or transformers it will protect itself from failure by turning the lights down or off until the load is corrected.