About this deal
mechanical fixings. The mechanical load that may be applied to butyl rubber adhesives reduces as the temperature increases. characteristics. They are not suited for continuous heavy mechanical loads and cannot replace the use of assembly adhesives or The user must ensure that the adhesive is compatible with the subsurface in terms of adhesive strength, paint compatibility and
Joint Waterproofing - Sika Joint Waterproofing - Sika
hard into the subsurface (use a pressure roller). Butyl adhesive tapes are by their nature plastic and have no elastic subsurfaces must be pre-treated with Multi Primer. Pull off the cover paper from the layer of adhesive on the rear, and press the It is used for waterproofing joints in a wetroom application. Examples of this would be between the tray and floor, floor and wall and up the corner of the room.Helps to make watertight seals for leaking pipes or waterproofing. Suitable for jointing, splicing and repairing cables, hoses, plastic and metallic tubes.
Megatape Waterproof Sealing Tape 10m - Tiling Supplies Direct
Butyl Tape DS down. Once fixed in place, continue pulling off the cover film / cover paper at the same time as continuing to press the product down hard to prevent the formation of air bubbles. To prevent any loss of adhesive strength, you must ensure that the Butyl Tape DS takes on the contours of the subsurface once fitted. After fitting, therefore, Butyl Tape DS must be pressed down chemical compatibility (perform own tests). The subsurface must be clean, dry and free of dust. Porous and absorbent