Drayton DIGISTAT +3 22083 7 Day PROGRAMMABLE Room Thermostat

Product Information

Reset the Digistat thermostat by going into the setting menu, selecting the Inst03 menu (installer settings) and then rSEt20 to reset to factory settings. Then remove the batteries. To swap between Heating and Hot Water on the thermostat press the setting button (cog symbol) to open this open. The Drayton Digistat+3 is a thermostat designed for controlling heating systems in residential and commercial buildings. It is manufactured by Drayton, a well-known company in the field of heating controls. The Digistat remembers the last BOOST so if you always use the same parameters just press the O button once. Simple!

Yes, there is a Digistat to suit both types of boiler – try our product selector to find the right one for you. How do you boost? There may be other Digistats powered up and within range and this will slow down the pairing process. If it is possible to depower the other Digistat please do this while you are pairing, or if not then press “I have done these steps” and wait for the RETRY button to appear. On the second attempt the pop-up should appear instantly. The Digistat is universal because it can be used as a fully-programmable thermostat or as a simple manual thermostat. In fact it contains 4 types of functionality: 7-day programming When used with a gas boiler the Digistat will automatically cycle the boiler to help your boiler to run more efficiently and save you 10% on your heating bill (compared to a simple ON/OFF thermostat). Yes, there is a Digistat to suit both types of boiler – try our product selector to find the right one for you. Do I need an OpenTherm boiler to use Digistat?When used with electric heating the Digistat cycles the heater at 12 cycles per hour to maintain room temperature and save money.

The Digistat qualifies as one of the additional measures required when replacing a boiler. In fact it qualifies both as a Smart Control and as Load Compensation. Which Digistats are being replaced? 2290B With its advanced programming capabilities, the Digistat+3 allows users to set different heating schedules for each day of the week. This can help to optimize energy consumption and reduce heating costs.When used with an oil boiler the Digistat will allow the boiler to run without cycling for improved efficiency.

Preset 3 provides heating all day long How is Digistat suitable for visually-impaired tenants/homeowners? These settings appear in the installer menu and it is important to select the setting for your heat source: gas boiler (default), oil boiler, heat pump, or electric heating Depending on the fuel type you select during installation will affect how Digistat works with your boiler/heat source - so ensure to select the correct type during installation. Does Digistat work with combi-boilers and conventional boilers? When a boost is selected, a timer symbol appears in the bottom right of the display and remains until the next event. Reset the Receiver by pressing the button for about 15 seconds until you see a red light followed by flashing orange/green which shows it is in pairing mode.In either mode the radiator or tap icon will be displayed. How do I change from Automatic to Manual mode? This option has no schedule and controls by temperature only. You set your preferred temperature and adjust it with the + and - buttons. The Green Premium eco-mark stands for complete, transparent, and easily available information about products When used with a Heat Pump the Digistat will protect the compressor by reducing cycling to 3 cycles per hour, to improve the life of the compressor. This groups weekdays and the weekend separately, so you can set a schedule for your weekdays and a separate schedule for the weekend.