UPol DOLPHIN GLAZE PUTTY

Product Information

Dolphin glaze is “pinhole resistant” and will help to fill any pinholes and minor scratches before sending it to paint. Gone are the days of localized putty repairs. If you want the best finish, finish your repair with a skim of glaze. METAL GLAZE is a two-part polyester finishing and blending putty. Just like dolphin it can be mixed in with other body fillers to offer flexibility and completely change the products you’re working with.

Using and mixing glaze with plastic fillers and aluminum fillers will make them much easier to apply and rub, you should definitely try it.Again, clean the panel after with a degreaser to remove the dust, dirt and debris before filling. The last thing you want is dirt in your filler, this is what leads to defects such as pinholes. Application Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie. U-Pol recommend P80 paper to sand and prep bare steel but suggests using P180 for any other surface. If you’re applying to paint all that you need to do is key the surface with 180 paper or a sanding disc. After you’ve sanded the area, U-Pol suggests using a degreaser to clean the panel. I can tell you from experience that using air to blow dust and debris from the panel also works. Application If you’re applying it to anything else, all you need to do is key the surface with P180 paper before applying.

It’s recommended to use 2% hardener with this glaze. Evercoat recommends adding a “ribbon” of hardener from edge to edge, as this works out to roughly 2%. Using the guidelines above, you can expect to rub your filler after 20 minutes. It’s recommended not to use more or less hardener, it speeds up the process but can also result in defects later on. Rubbing At the end of the day it comes down to personal preference and the only way you’re going to know which one works best for you is by trying them out.However, if you’re using it for decent size fills and mixing it with everything, you’ll go through a lot of it. Putting a final “skim coat” on top of your repair will completely change the quality of your repair. I’ve had painters thank me for this in some workplaces. Try not to apply as much pressure to the spreader when applying the glaze, otherwise, you’ll still be left with low spots.

If you’ve got as close as possible to a metal finish, a skim of dolphin on top could be enough to finish the repair. After application, the glaze should turn to gel within 5-8 minutes and be ready to sand within 15-20.Self-leveling – Depending on how good you are at applying filler, this could be a very helpful feature. It’s a 2 part system where you mix the glaze with a hardener normally 100 parts glaze & 2 parts hardener.