276°
Posted 20 hours ago

Sentinel - X100 Inhibitor 1L, Market Leading Heavy Duty Central Heating Inhibitor, Protection Against Corrosion and limescale, ensures Maximum Heating Efficiency and extends System Life, Clear (88000)

£123.495£246.99Clearance
ZTS2023's avatar
Shared by
ZTS2023
Joined in 2023
82
63

About this deal

Ideally, on the return pipe leading to a boiler. This is to stop debris entering the boiler and damaging it. Maintaining system health is essential for ensuring that it runs both reliably and in an energy-efficient way, working towards Carbon Reduction Commitment goals whilst keeping employees or patrons comfortable. The Workplace (Health, Safety and Welfare) Regulations 1992 states that: Close the radiator valves and then slowly remove the adaptor from the radiator, catching the excess chemical in a container. Isolate the filter from the system and remove the bleed pin from the valve at the top of the filter. Catch any excess fluid with a rag. Close the filter valves and then slowly remove the adaptor from the filter, catching any excess fluid with a rag.

Do you have a modern condensing boiler, especially a combi? (That combination makes a clean system really important as the very narrow waterways can clog quite easily, as I know to my cost.) Anyhoo, you'd be NUTS to not fit a magnetic filter on the return pipe to your boiler. As KIAB says, it'll keep on collecting the small bits of sludge as they get loosened over time. Go to the filling loop and locate the threaded hose connection point at the system end. The hose should be connected to the system through a ball valve. If a filling loop is fitted and accessible use Method 1 to dose via the filling loop stop valve, if not use Method 2 or 3 to dose via the radiator. Alternatively, use Method 4 to dose via the bleed valve if a Sentinel Eliminator or Eliminator TotalGuard filter is fitted. It is also possible to dose via an Eliminator Nano, but only if complete isolation is achievable.

Place a number 1 tablet and a number 2 tablet into the test tube provided. These are clearly marked. Thread the ½” female BSP adaptor onto the exposed male threads at the hose connection point on the ball valve. Use a spanner to gently nip up the adaptor to ensure a water tight seal. Vortex250 units feature an integrated isolation valve, a voiding the need for a strip down service; and a front-facing magnet, ensuring that where space is at a premium, no further space is required as the magnet can simply be removed at the front.

a deeper yellow than or the same depth as the ‘Standard’ yellow band, the concentration of Sentinel X100 Inhibitor is satisfactory for system protection. Circulating debris in central heating systems can cause wear and premature failure of pumps, valves and heat exchangers. Sentinel's filters are the perfect filter solution to protect the system against magnetic debris. Remove the adaptor from the system. The hose can be reconnected but should always be disconnected at one end to avoid the risk of any contamination of the fresh water supply.Sentinel's range of filters is crafted to fit any situation. The filters we offerrange from ultra-compact, where space is at a premium, through the compact Vortex300 and the larger Vortex500, which is also suitable for heat pump installations. We recommend that a filter is installed on all systems, in conjunction with a cleaning of the system, to capture any existing debris. Our range of cleaners is comprehensive and can be choosed based on the scenario that presents itself. See our cleaners and system cleaning-related products here. Allow to stand for 10 minutes, shaking from time to time. The solution should change colour during this time. The associated ACOP goes on to explain that the ‘temperature in workrooms should normally be at least 16 degrees Celsius unless much of the work involves severe physical effort in which case the temperature should be at least 13 degrees Celsius.’

Asda Great Deal

Free UK shipping. 15 day free returns.
Community Updates
*So you can easily identify outgoing links on our site, we've marked them with an "*" symbol. Links on our site are monetised, but this never affects which deals get posted. Find more info in our FAQs and About Us page.
New Comment