About this deal
For EXTRA porous hard surfaces such as these, first apply PRO CONTRACTORS SOLVENT in an inconspicuous area using the techniques below. Measure this success before applying PRO CONTRACTORS SOLVENT on a greater scale. First, make sure the surface you apply CITRUS SOLUTION to is NOT HOT. After applying, then removing, CITRUS SOLUTION (and the challenge), include an extra water rinse on the surface (to be certain no residue remains on the surface to be heated). Often a moist paper towel or moist sponge suffice for the rinse. Then let the surface dry thoroughly. IMPORTANT: After using in dryer or on appliances or elements that produce heat, remove product thoroughly with mild soap and water AND LET DRY BEFORE USING appliance. Laundry Test pressure washer for surface compatibility, with and without the cleaner, in an inconspicuous area.
From virtually any surface including automobiles, dry paint, glass, porcelain, fiberglass, vinyl, wood and much more. Even from laundry, skin and hair. See directions below for list of prohibited surfaces. Remove as much of the ‘glossy’ part of the label, adhesive residue or chewing gum without harming the surface. For tougher applications such as caulk, silicone and hardened floor adhesives,let sit 10-25 minutes before wiping. KEEP MOIST WITH INTERMITTENT SPRAYING and determine timing of bond release. Once determined, apply in necessary volume according to size of surface area.Wash the fabric using a pre-wash programme in accordance with manufacturer’s instructions.Add slightly more detergent and use the highest temperature setting recommended for the fabric. NO HARMFUL VAPORS • No Benzene • No Xylene No Phosphates • No Toluene • No Chlorinated Solvents • Non-Corrosive • Non-Toxic • POWERFUL, YET GENTLE ON EQUIPMENT AND SURFACES. Hard Surfaces
PRO CONTRACTORS’ SOLVENT is a stronger version of CITRUS SOLUTION and removes even tougher challenges including caulk, cured silicone, water seal, roofing tar, asphalt and fresh expanding insulation foam. YES. CONTRACTORS SOLVENT will not harm dry paint or clear-coat finishes. This product is an excellent wax remover so after removing asphalt, grease and tar, you may want to rewax your vehicle. To clean interior stains, use the instructions for carpeting and upholstery. CONTRACTORS SOLVENT may also be used on vinyl and non-tinted glass since tint is usually applied with adhesive. Be sure to wash CONTRACTORS SOLVENT off vinyl and rubber surfaces after use. Can I use CONTRACTORS SOLVENT on dry paint? + a>