Joined in 2023 
82 
63 About this deal
Application/Limitations: Efflorescence must be treated with Efflorescence Remover before application. Nanoman Raw Timber is a high-performance, nanotechnology enabled, penetrating sealer for the protection of all types of unpainted timber. It is a clear, colourless, breathable, abrasion-resistant, easy to clean, waterproofing coating designed to protect these surfaces from water damage, stains and marks caused by liquid spillages, food stuffs, and external pollutants such as dirt, bird droppings and leaf staining.
Yes. Nanoman Raw Timber can be used on any raw timber surface both inside and outside the home and is perfect for protecting your brand new or used kitchen bench top. This sealant has been certified as food safe and is therefore ideal for use in food preparation areas. PROVIDES A WATERTIGHT SEAL. The perfect product for a leaking basement wall or building foundation works by creating a watertight seal to keep moisture away. applied, to ensure 100% performance efficiency. This varies with substrate, and treating a small trial area is recommended to calculate true consumption.
EASY TO APPLY - No primer is needed prior to the application of waterproof invisible sealant. Apply immediately for instant waterproof protection. Clear the affected area of moss and debris and remove any surface water, oil or grease. If you are in an environment that produces a lot of friction against the coated surface i.e. a windy desert or seaside location, its life span may be shortened. Foot traffic will also lessen the life span of the sealant. As Sealers Direct has no direct control over the methods employed by the user in applying its products, any warranty either written or implied is given in good faith and can only cover the material itself
Are you looking for a solution to your leakage problem? Waterproof Invisible Nano Sealer is a rubberized paste that effectively seals and repairs broken surfaces. It is a water-based sealant that is paintable and can waterproof a large variety of surfaces. Re-application: Subsequent applications MUST be applied “wet on wet” within 10 minutes of previous application. All surfaces should be porous, clean, dry and free from loose debris, flaking material, dust, dirt, grease and vegetative growth.Use brush supplied to apply as a film directly onto and covering the seam stitching or hole. Stormseal will soak into the stitching or hole. Allow to cure for 15-25 minutes or until clear and dry. SAFE & NON-TOXIC. It is formulated with odorless and non-toxic substances. It will not damage surfaces and will not cause pollution.
Water repellence is evident after initial curing but may take up to 7 days to reach 100% efficiency. It provides a rigid but flexible layer of protection to the applied surface. It is leakproofand can be used on wet surfaces with high bonding strength. It is transparent and has a non-yellowing substance. Nanoman Raw Timber has been designed to protect raw timber against water damage and decay whilst allowing it to age and grey naturally. With its hydrophobic properties, Nanoman Raw Timber ensures the integrity of the timber is preserved by inhibiting rot, mould, moss, algae and mildew growth. Once applied, the microscopic nano-particles form an invisible protective layer that creates a water repellent surface as well as penetrating into the pores of the timber to provide long lasting protection.All surfaces must be treated to saturation in 1-3 applications “wet on wet” applied, to ensure 100% performance efficiency. This varies with substrate, and treating a small trial area is recommended to calculate true consumption. Stormseal is a water-based aqueous styrene-acrylic type polymer dispersion seam sealer. The liquid soaks into pinholes and leaking seams and dries clear, leaving a flexible and impermeable waterproof surface. Do not use chlorine, bleach, sodium hypochlorite, acid, Paveclear or Paveclean chemicals on surfaces intended for Invisible sealer Nano
Great Deal 
New Comment