Joined in 2023 
82 
63 About this deal
Please note: limescale can cause serious damage to your ice machine. We recommend a water filter is fitted to reduce limescale and maintain ice quality. Alternatively, you can wait for the ice to melt off the evaporator after turning off the ice machine. E07: Starving TXV Single Evaporator or Low on Charge. Ten consecutive occurrences where the difference of average evaporator inlet T3 and outlet T4 is greater than 12 degrees Fahrenheit in the last one minute of the freeze cycle. Add the recommended amount of Manitowoc Ice Machine Sanitizer to the water trough by pouring it between the evaporator and water curtain. Refer to your user’s manual for the proper amount to use. A dirty evaporator will hold ice and not allow it to fall until it is mostly melted away. Because there is not enough ice to force the water curtain open and break the bin switch, the machine simply thinks it never harvested. 3. Malfunctioning Bin switch
When sanitizing, pay attention to the same areas as before (Bin/Dispenser, Base, Plastic parts of evaporator (top, bottom and sides), and Side walls) The slime and mold also form because the ice-making process is exposed to the air. The air, is filled with many contaminants, including mold spores and bacteria that can lead to a dirty ice machine. Losing the water that is supplied to the ice machine can also cause an empty water trough. This can be caused by a leaking dump valve or a water trough that is damaged or not properly installed. Be sure to read and follow all directions and recommended mixture ratios as stated in your ice machine’s user manual. The ice machine isn’t level – Make sure the machine is level. The machine must sit flat on the floor for optimal performance.
Interactive Electronic Document Catalog (EDC)
DO NOT mix bleach with other cleaners. The combination can produce harmful, toxic fumes that can cause respiratory distress. A dirty machine can slow down the harvest cycle or impede ice from releasing. Clean and sanitize the ice machine following the instructions in the owner’s manual. The Ice Machine isn’t level The water pump works by taking the water from the water trough, pushing up through the tubing, out and over the evaporator through the distribution tube. It’s important for the water pump to be strong enough to push an even flow of water, but not too strong to cause the stream of water to miss cascading down the evaporator.
If the freeze time reaches 60 minutes, the control board automatically initiates a harvest cycle. If 3 consecutive 60-minute freeze cycles occur, the ice machine stops. Efficient, functional and with a huge 45kg capacity ice bin, the Manitowoc NEO ice machine is an advanced, class leading ice maker designed to be used in the most demanding of commercial environments such as stadiums, canteens, educational establishments and large restaurants. The NEO provides crystal clear, dice shaped ice consistently whilst using less energy and water than other comparable ice makers in its class. Designed in conjunction with professional caterers, the Manitowoc includes a removable ice bin and air filter, making the unit easy to empty and clean, whilst the ice is easily accessible with the angled access door. Includes energy efficient “delay” mode, meaning ice production can be suspended as required, saving water, energy and money. Transparent window view lid– Provides easy viewing to see how many ice cubes are left without opening the lid and letting cold air out. E11: Refrigeration Fault. The compressor discharge temperature didn’t increase by at least one-degree F and the evaporator temperature. The water temperature is too high – Ice machines require a cold water supply. Make sure there is not a hot water supply line into the machine.An ice machine is a crucial kitchen gadget if beverages are the main part of your menu. As such an optimally performing ice machine is key to your success. Keep reading to learn how to maintain and troubleshoot your Manitowoc ice machine for optimal performance all year round. Manitowoc Ice Machine Not Making Ice If the ice is thin at the top of the evaporator, continue reading for the solution further down in this post under the problem “shallow or incomplete cubes.” Manitowoc Ice Machine Keeps Running Another reason the ice maker is not working is a faulty compressor. The Manitowoc ice maker will not make ice if the compressor does not start. E32: RS485 Communication Fault. The device plugged into the RS485 port is not communicating with the control board and gateway
Great Deal 
New Comment