Joined in 2023 
82 
63 About this deal
Drive the vehicle on a level road at a steady speed of approximately 20mph (32kph) and progressively apply the service brake to maximum. For the majority of vehicles, the MOT testing service will calculate brake imbalance automatically. However, when this is not the case, such as for tricycles and quadricycles or if MTS is not working, you must calculate the brake imbalance against the maximum brake efforts on each axle in the following way: Moisture-Laden brake fluids may cause metallic components in the braking system to corrode and rust, which results in your brake fluid having rust particles. You should always ensure the brake fluid reservoir cap is closed tightly to prevent dirt or any debris from making its way into the braking system. The results would be reduced efficiency in the braking system, which is a safety concern.
Brake Fluid: 9 Steps (with Pictures) - wikiHow How to Check Brake Fluid: 9 Steps (with Pictures) - wikiHow
If MTS is not working, add the brake efforts from each wheel for the system that is being tested and carry out the following calculation: Drive the vehicle on a level road at a steady speed of approximately 20mph (32kph) and progressively apply the parking brake to maximum. It may be possible on motorcycle derived systems for the brake lever to touch the handlebar. In such cases the extent of reserve travel should be assessed during the brake test. Defect If the vehicle or system cannot be tested on a roller brake tester, set up the decelerometer in the vehicle as instructed by the equipment manufacturer.A brake disc or drum must be significantly worn before you should reject it. Being worn below the manufacturer’s recommended limits is not a reason in itself. Defect i) the braking effort from any wheel is less than 70% of the maximum effort recorded from the other wheel on the same axle. Or in the case of testing on the road, the vehicle deviates excessively from a straight line. i) the braking effort from any wheel is less than 70% of the maximum effort recorded from the other wheel on the same axle. Or in the case of testing on the road, the vehicle deviates excessively from a straight line For a while,brake fluid test stripshave been in use to measure the mineral or moisture content n brake fluid. However, these chemical strips can be costly, and they have to be disposed of after use. Fortunately, modern technology led to the invention of an LED brake fluid tester. The LED brake fluid tester is inexpensive, reusable, and more accurate.
Best brake fluid testers 2023 | Auto Express
A brake fluid warning lamp may be shared with other components, for example to indicate that brake pads are worn or the parking brake is applied. Class 3 vehicles are not inspected for brake fluid warning lamp. Brake fluid is essential for ensuring your brakes work as they should. It transmits the force applied when your foot pushes the brake pedal to the brake calipers or wheel cylinders, which then applies the brakes and slows down or stops the vehicle. Brake fluid also lubricates the hydraulic system and helps prevent corrosion, so it’s important to keep it sufficiently topped up. In cases where the required brake efficiency is only just met, but the tester knows that a higher performance figure is normally obtained for the vehicle type, the vehicle presenter should be informed. Defect
Conclusion
Some vehicles with full power hydraulic braking systems will illuminate the low-pressure warning light as soon as the ignition is switched on. It is not a defect unless the warning light stays on after the engine has been started. Defect The brake fluid chosen to put into the hydraulic system is critical, with VMs recommending a specific type of fluid that should always be adhered to. e) The strength or continuity of the load bearing structure within 30cm of any braking system actuation component mounting (a prescribed area):
Great Deal 
New Comment