APC - AP9640 - UPS Network Management Card 3, Black

Product Information

On the APC SMX1500RM2U is a slot for a APC Network Management Card. After some research I learned it will take either the AP9630, AP9631, AP9640, and AP9641 all of which are hot swap-able. The difference between the AP9630/31 and AP9640/41 is the network speed of the card. The AP9630/31 are only 10/100 speeds, and the AP9640/41 are 10/100/1000 speeds. The AP9631 and AP9641 can hook up temp monitoring and it has some other ports. Connect the provided serial cable (part number 940-0299) to the selected port at the computer and to the configuration port at the Management Card. Access to the same tabs and menus as a Device User above, but without the capability to change configurations, control devices, delete data, or use file transfer options. Links to configuration options are visible but disabled. (The event and data logs display no button for this user to clear the log). Make UPS information available to your preferred network, server or enterprise management system by forwarding SNMP traps (events) using RFC 1628 MIB.

InfraStruxure Central — Provide enterprise-level power management and management of agents, UPS devices, and environmental monitors.The APC AP9640 UPS Network Management Card 3 allows you to remotely monitor and control an individual UPS by connecting it directly to the network. NOTE: This wizard will also not workwith any Network Management Card familyif the NMC was previously configured and not in DHCP or BOOTP boot mode. v5.0.0 and higher of the wizard, available from apc.com, allows you to locate unconfigured cards or locate configured cards on the network by IP range.

Press E NTER, repeatedly if necessary, to display the User Name prompt. If you are unable to display the User Name prompt, verify the following:below are Web-based, IPv6 Ready products that manage supported devices using multiple open standards such as: NOTE: Tests have shown that even with the network properly configured, the ability to reference devices that support this option is not immediate.In APC tests, it took between 6 and 16 minutes before this functionality worked. However, it worked every time (max wait 16 minutes).Depending on your network setup, your experience may differ.

The default values for these three settings generally do not need to be changed: -v : APC If your network is setup correctly (described below),you will be able to access "unconfigured" / just-out-of-the-box NMCs by referencing the NMC as follows:

Hard drive retention: Hard drive retention is not available on models with a soldered hard drive, including XPS 9315 2in1, Chromebooks or Venue tablets, except the Venue 11 Pro. Integrate your UPS to existing networks with 3rd party Building Management System and Industrial Automation Systems Finance is only available to permanent UK residents aged >18, subject to status, terms and conditions apply.

Description: View the existing RADIUS settings, enable or disable RADIUS authentication, and configure basic authentication parameters for up to two RADIUS servers. Description: Initiate an update of the UPS firmware. The firmware update file must have been previously sent using FTP to the NMC and stored in the /upsfw/ directory. For local access, use a computer that connects to the Network Management Card through the serial port to access the command line interface: printed format and on the Network Management Card Utility CD in PDF to configure the TCP/IP settings of theIPv6 network configuration provides flexibility to accommodate the user's requirements. To configure the TCP/IP settings for IPv6, see the user interface online help for details on the options: Manual, Auto Configuration, DHCPv6 Mode under this menu: Administration > Network > TCP/IP > IPv6 settings. Network management features Identify problematic trends and take appropriate action before they escalate or export logs for analysis Monitor and manage your UPS as one of your network devices over your preferred Enterprise Network Management System by forwarding SNMP traps (events) across SNMP (v1/v2/v3) using the PowerNet MIB.