HB Body 222 Bumpersoft Car Body Filler Black Putty For Plastic Bumpers 250g With Hardener Excellent Adhesion Easy To Sand With P120-P240

Product Information

Can be used from 15 to 30°C although pot-life and cure time will be affected significantly. Recommended working at an ambient of 20-25°C. Most of our flat plastic strips have square edges, but we also have a few sizes with round edges. This means that two of the edges of the plastic strips are slightly rounded. Square edge plastic strips

Apply adhesive. Apply it sparingly to one surface and press the parts together immediately. Hold in place until the bond sets. Do not reposition parts. Spacers and gap fillers, as the plastic strips can sit between two edges or slide underneath an edge to fill a gap. The filler is supplied complete with the necessary fast epoxy hardener which will cure the filler in around 2hrs. Prepare surfaces. Surfaces should be close fitting (pre-fit before joining), free of residue, and dry. Slightly roughen smooth surfaces to improve results. It depends on whether you choose rigid plastic strips or flexible plastic strips as to how bendable the plastic strip will be.

Choosing a repair kit

Firstly, an explanation as to what uPVC actually means. PVC is an abbreviation for ‘polyvinyl chloride’ and ‘u’ is an abbreviation for ‘unplasticised.’ Therefore uPVC means the material is unplasticised polyvinyl chloride. Thoroughly clean the bumper inside and out. Any dirt or grease will stop the filler bonding properly and ruin the appearance of the repair. Allow to dry and wipe down with solvent wipes, which are usually included in the kit.

Apply activator (if applicable). If you are using an activator, apply it to both surfaces unless otherwise indicated. Wait until it has dried completely, then proceed with the adhesive.Our plastic flat strips are manufactured in PVC and are solid all the way through, both in terms of material and colour. We get asked sometimes if our flat strips are foiled, with the colour just being on the surface of the product. They are not foiled, they are high quality products and are a solid colour all the way through. Bendable plastic strips Once hardened, finish the sanding with wet fine grit sandpaper for a really smooth finish and wipe away any dust. Apply a liberal amount of repair material to the damaged area so that you make the surface a little higher than surrounding bumper. Use a spreader like a squeegee to carefully smooth out the filler. Make sure to push the filler into any scratches to fill them right to the bottom. Cover with smoothing film if supplied and allow to dry and fully harden.

If you require thin plastic strip take a look at our range and see if we have a suitable size. It is possible for us to manufacture thin strips of plastic to other specifications but this would be custom production so is subject to much larger production runs, normally around 2000 metres. The minimum production runs would vary depending on the size of the profile and can be quoted upon request. uPVC strips - an explanation Prepare adhesive and activator (if applicable). Open the adhesive and, if relevant, the activator according to the manufacturer’s instructions. Gather materials. Get together all the plastic pieces you want to join. You’ll also need and your adhesive, of course, tissue paper, something to protect your work area, and sandpaper (for bonding smooth surfaces). Rigid PVC strips are manufactured from a different material to our flexible plastic strips and we encourage you to request samples if you are unsure which material to choose.

After any paint repair, it’s best to wax the car, preferably professionally to keep the paint in the best condition. Wait at least a week after the repair before waxing. You are very welcome to request samples of PVC strip if you are unsure about exactly which plastic flat strip you need. You may wish to see the colour, the different type of material, the width or the edge style.