About this deal
No Sorry. Green as in the tanalising. The wood is fairly new and has been stored in the shade, but we have had a dry few weeks.
Decking Spacing | DIYnot Forums Decking Spacing | DIYnot Forums
if your boards where stored out doors and where completly saturated you could expect 6 to 9mm shrinkage on a 150mm board When I do a search on recommended gaps I see anything from 3-6mm stated. Having done a search on here I see that 5mm is the recommended amount. Ecodek is a trading name of Specialist Building Products Limited, a wholly owned subsidiary of the Epwin Group.If you are collecting timber products please collect at the time bookedi.e. 9am collection would be 9am > 9:45am, this helps us have the product ready for your slot and reduces customer congestion. At Southgate Timber one of our biggest strengths is our fast and efficient delivery service. Based in Moreton CM5 0JA, near Harlow in Essex close to the M25 we cover the whole UK mainland. Access must be suitable for lorries which will be 3.5 tonne 7.5 tonne or 14 tonne lorries (7.5 tonne being similar to average refuse collection lorry) My mate is so concerned that he is considering taking up the ones that he has screwed down and re-spacing them at 3mm. Is this wise? Will involve some work but he is more concerned about the finish.
Spax – Decking Spacers | Chiltern Timber
For precise delivery price please enter products in your basket then enter your postcode in the Delivery cost Calculator below. If the boards are absolutely dry though when laid then this gap will be too small and the boards will warp during the winter months when they expand due to moisture retention and I would lay with 4mm drills as spacers in this case. The key point was at the start ... What is the level of moisture content in the boards when they are to be laid. I intend to lay them all across the joists to dry out as I will not be working on it again for the next week or so. However it is now raining
Allow the WiseGuides ® board spacers in place during installation and extract them upwards simply by the handle following