Bestway Underwater Adhesive Pool Kit

Product Information

Whether you have an Intex paddling pool, Bestway paddling pool or another popular make of paddling pool. Finding and fixing a hole couldn’t be easier. Finding the Hole in your Paddling Pool

First, you need to find the hole in the paddling pool, and then you can fix it using a suitable paddling pool repair kit. Deflate the liner slightly to eliminate the bulging. Please be aware changes in the ambient temperature outside will cause the air inside the liner to expand or contract. On hot summer days we would suggest deflating the pool ring slightly. On colder winter days you may notice the liner looks a little soft and needs some more air. Yes, you can use sellotape to temporarily repair a paddling pool but it will only hold for a very short period of time. Sellotape does not like water and will peel off in no time at all. To fix a puncture you will require a repair kit. We would suggest using a waterproof repair patch or epoxy vinyl glue. Most paddling pool repair patches need to be fixed to a dry surface and the pressure of the water or air will also cause extra pressure which may prevent the patch from adhering fully.

About 10x HEAVY DUTY REPAIR PATCH

This is normally caused either by the pool not being set up on flat level ground or someone standing or leaning on the frame of the pool. We would suggest moving the pool to a more suitable location. We would also advise that you do not stand on the frame of the pool, the ladder must be used for entering and exiting the pool. This type of damage is not covered under the manufacturer’s warranty so you may need to replace parts. Parcel tape can be a little better than sellotape but it will fail to work on the same principle as neither like water and will fail in a short period of time. This change of mind return policy is in addition to, and does not affect your rights under the Australian Consumer Law including any rights you may have in respect of faulty items. To return faulty items see our Returning Faulty Items policy.

The first part of fixing a hole in a paddling pool is finding where the hole is located. Finding a hole that is letting water out is quite simple, you just need to look to see where water is escaping. Duct tape will last slightly longer than sellotape and parcel tape but will still not last very long. You may get a couple of uses out of your paddling pool with duct tape on it but you’ll find that your time will be wasted in the long run.

You may also like

This is normal. The pool will bend inwards until the pool has been filled up to 80% capacity. Please see the pool manual for more detailed information and images. Paddling pool repair patches should be applied to clean and dry areas. You must ensure that before you apply the patch, you clean off any dirt or debris and then dry the area thoroughly.