About this deal
Of course), full chrony and fpe calculations and accuracy results will follow, if I find something that works. Set the pistol into the foam cradle after your three shots and enthuse while the other person shoots. I believe the long Gats were made near the end of the company’s run, in an unsuccessful attempt to revive the product line.
It's important to know that due to state and local laws, there are certain restrictions for various products. The barrel acts as a piston guide up through the middle of it and has a washer or something or other with a gasket just ahead of the vent holes that acts as the stop for the piston. It has a flange on the other end to play against the rather big rubber breech seal which, to me, is one weak point in the system as it seems that the rubber seal is not made of stern enough stuff. Over the years I have read things about Gats and one of them is that, while there may be many Gat-like airguns, the true Gat only comes from T.The homosote is the key feature in my setup with the paper target because homosote has a good density that allows penetration and there is no bounce-back ricochet. A cocked Gat appears to have a fixed circular barrel protruding from a receiver that is also of roughly circular section.
There are those that would just ban them, but then there are those who would ban anything that has any remote risk involved.
The small end of the arrow got a wrapped string ring to act as a seal and align the arrow in the bore. I wonder how accurate it will be when a broadhead is attached to the shaft – velocities are pretty high. This was later made under other names and I have two new in the boxes Champion J50’s which I believe were the last re-incarnation. I may even try darts in a break barrel M-8 that fits me well but won’t shoot pellets accurately enough to be fun.