National Hardware V852 Anti-Sag Gate Kit

Product Information

The gate brace is manufactured from durable, tubular steel, and is powder-coated for years of reliability.

Sometimes, the weight of the gate can cause the post to lean in the soil, leading to a sagging gate. If any of the screws rotate with very little pressure applied when you are tightening them, this means that they are no longer properly holding.Normally a cross brace should have served the purose, and if the hinge post was left lenger and protuding above the height of the gate the cross barce would have attached to the very top of this post, helping to conteract the forces that allow the gate to droop.

It's formulated to withstand the harshest weather conditions and stand up to the corrosive effects of pressure treated lumber. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging . The Gate Brace is manufactured from durable, tubular steel, and is powder-coated for years of reliability.

Drill holes in the flattened ends, then lift the sagging side of the gate so it's a little higher than level and attach the conduit across the gate's diagonal, from the upper hinge to the lowest (sagging) corner. If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag. any half descent ships chandlers will make a set of cables up together with the various ends and thread coupler, the coupler is a left and a right handed threaded "Buckle" scewwing onto the threaded rods, simply turning it clockwise will increase the tension, it might well be in Stainless but you should be able to get it in Galv finish. If the gate is large—say, wide enough to drive your lawn tractor through—you're better off with something a bit more substantial. When I started work in the mid XXs we used to fit TV aerial lashings to chimneys this way, can still show you some I put up.