TP-Link JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots, Supports 24 Gigabit RJ45 ports, Rackmount (TL-SG3428)

Product Information

Feature Filter: All Configuration Guide User Application Requirement Further Assistance Troubleshooting When You Set Up FAQs For example, to enter the show command, you can type “ sh”, then press the TAB key, or type a question mark immediately afterward, like “sh?”, then the switch will automatically complete the interface command. Note that the question mark will not be displayed. You can enable Fast Leave by enabling the feature for both the VLAN and the Port when there is only one client connected to the access port. Feature Filter: Tutto Configuration Guide User Application Requirement Further Assistance Troubleshooting When You Set Up FAQs What should I do when the Omada Software Controller (V4) fails to discover the devices? 11-23-2021 87590

Ports 2, 3, 4 are used as access ports to connect computers. The following configurations describe how to add port 2, 3, 4 to the corresponding VLANs and set PVIDs.It's recommended that users stop all Internet applications on the computer, or simply disconnect Internet line from the device before the upgrade. IMPORTANT: To prevent upgrade failures, please read the following before proceeding with the upgrade process Using the Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 06-08-2023 17569

Normally, all switch ports are member ports of VLAN 1. If you do not want to remove a port from VLAN 1, you need to additionally configure it. Yes. Requiring the use of Omada Cloud-Based Controller (Supported byTL-SG3428MP v1, v2, v4 and above, while is not supported by TL-SG3428MP v3) A firmware update can resolve issues that the previous firmware version may have and improve its current performance. To Upgrade Use the command “ip igmp snooping” to globally enable the function. There are three versions of IGMP, the default version is v3, which supports to process IGMP v1, v2, and v3 report messages from the host, thus normally there is no need to modify the version. Please note: The products of TP-Link partly contain software code developed by third parties, including software code subject to the GNU General Public Licence (“GPL“), Version 1/Version 2/Version 3 or GNU Lesser General Public License ("LGPL"). You may use the respective software condition to following the GPL licence terms.The querier is essential for IGMP Snooping to work properly. Usually, a router in the network can act as a querier. The switch can also act as a querier, but it is disabled by default, if you need to enable it, you can configure it as follows. IGMP Snooping helps the switch maintain a multicast forwarding table by snooping the IGMP transmission between the host and the IGMP Querier. With the forwarding table, the switch can forward multicast data only to the ports that are in the corresponding multicast group, to constrain the flooding of multicast data in the Layer 2 network.