SFS Dynamic 2D Door Hinge White Cover Cap Only

Product Information

Concealed hinges: these mechanisms perform the same function as butt hinges but can’t be seen when the door is closed, allowing for a smoother, invisible aesthetic Measure up: for the door to hang correctly, the recommendation is to place the first hinge five inches from the top of the door and the second hinge ten inches from the bottom. Measure out these distances on the door and the jamb and make a mark. Then place the hinges at the centre of this mark and trace their position

Flush hinges: flush hinges are designed to sit on top of surfaces and can be installed with no recess needing to be cut, making them ideal for lightweight applications Tee hinges: named after their shape, these hinges have a rectangular and tapered leaf which makes them suitable for heavy-weight applications

A loose top hinge: because this hinge bears most of the weight of the door, if it is sagging or coming away from the top edge, it’s likely to be because the top hinge isn’t screwed in tightly enough, or the screws used aren’t long enough to support the weight. Tightening up or replacing the screws on the top hinge should fix this problem Piano hinges: longer than a standard butt hinge, these hinges run along the edge of a joining and are often used in pieces of furniture or on cabinet doors

The hinges aren’t in the right place: if a door keeps opening and closing on its own, then it’s likely that the hinges aren’t in the right place to balance the door correctly. Depending on the type of hinge, you may need to take off the hinge, redo the recesses and re-screw the hinge. You can fill in any holes left over in the frame or door with wood and wood filler

Courier Delivery

Place and fix the hinge onto the cabinet door, either by putting it into the recess and screwing it in or tracing around the hinge, marking the screw holes, drilling in pilot holes and finally screwing the fixing in place. If your hinge has an arm, this should overhang the cabinet door by about half an inch to ensure the door can open and close properly Butt hinges: made to connect abutting surfaces, these hinges have two leaves with a barrel and pin mechanism Partially inset, where the inside of the door meets the sides of the cabinet, and the outside of the door partially covers its front edges Spring hinges: used most often on fire doors or in commercial properties, these hinges have a spring in the centre of the barrel that allows it to close on its own Many versions of two and three-part drill-in hinges are available for room doors. Many more versions are required for project doors to accommodate the frame profiles, material, load-bearing capacity and loads at each door, for which suitable hinges are required. The various door profiles require suitable hinge parts.