Armeg SSH3PCSET Sheet Steel Holesaws (3-Piece) , Red

Product Information

To adjust the size locate the inner edges of the blade holders against the size graduation. Forexample number “40” for a 1 9/16” (40mm) diameter hole.

Drill board using downwards pressure, keep SBC perpendicular to surface. Full depth is achieved when the stop ring forms a score on the board. Acceler8% MAX cutters can be used in standard portable power tools run on rotation only and any power tool with a range of 300 to 1000 rpm.The adjustable width blades allow users to benefit from a cutting diameter range spanning from 40 - 203mm on just one tool. This reduces the need to carry a holesaw for every sizegivinga great cost effective solution. When using in waterproof boards, if it is required to maintain the integrity of the board, it is advisable to seal around the edges of the rebated cap with silicone sealant or similar. Armeg’s Solid Board Cutter provides users with a simple and easy solution for drilling access holes in solid board flooring – no need for interjoist sawing.

When used together with Armeg’s removable solid plug caps, this product produces a neat access hole which lies flush with the floor and allows re-entry for future access requirements. Using cutting oil will extend product life and is imperative in stainless steel. Try our cutting compound (part number ECC002).

Product Guide

Hex Key included with replacement springs and pilot drills available to keep your cutter in use for longer Twin cutting blades provide balanced cutting, reducing the risk of a damaged hole and giving more user comfort. After pilot drill penetration, be careful not the "bang" the holesaw onto the durface of the material to be drilled. This could damage or break the cutting teeth For diameters greater than 50mm we do not recommend the use of Acceler8% MAX cutters in portable power tools.

Set 2 blade holders at the desired graduation on the measure bar by the screws using the hexagonwrench. SBC can be used with standard holesaw adaptors with a 5/8" - 18 UNF thread. Try the Hex Shank (part no. CHD32-64HEX) or the SDS Plus Shank (part no. CHD32-64SDS). Rapidly creating a 111mm diameter hole in under one minute, the Solid Board Cutter features 8% Cobalt HSS tipped teeth for durability, lasting at least 100% longer than a standard bi-metallic holesaw.The product also provides protection from falling debris making it a more efficient and hassle-free drilling experience. After pilot drill penetration, be careful not the "bang" the holesaw onto the surface of the material to be drilled. This could damage or break the cutting teeth

Adjustable width HSS cutting blades can be altered to cut between 40-203mm for the ultimate flexibility. When deep boring - 1” (25mm) up to a maximum - 1 7/8” (46mm) is desired, use the hole cutterfrom one side of the timber, and then start boring again from the other side until the cutting bladesbore a through hole making a doughnut shaped disc, as shown in figure 1, 2, 3. Set both cutting blades on blade holders tightly and correctly as shown in figure A. Figure B & C are incorrect.

It is not necesary to use any adhesive with the cap. The rebate and floor covering will hold in position. Repeat access is then very easy. Our holesaws fit standard adaptors - please see our range of Holesaw Accessories for a tip on how to correctly fit your holesaw to your adaptor After producing a hole, remove the "slug" of the material from the throat of the holesaw before commencing another hole Can be used in mild steel, stainless steel, steel plate, cast iron, aluminium, brass, copper, FRP (i.e. fibreglass) and plastic