276°
Posted 20 hours ago

AISEY 5cm x 9.2m Reflective Tape Waterproof High Vis, Reflective Tape for Vehicles Red & Yellow Safety Adhesive Tape Outdoor

£9.9£99Clearance
ZTS2023's avatar
Shared by
ZTS2023
Joined in 2023
82
63

About this deal

The lower line of the marking tape must be placed a minimum of 25cm from the ground and in a height of maximum 150cm. This can in special cases be extended to 250cm. Although this tape is very effective at reflecting light, it is not graded, so if you need a particular grade or specification such as for highways this tape is not suitable. The length of the upper corner markings must be minimum 25cm. Upper corner markings should be applied as high as practical, but within 400 mm of the upper extremity of the vehicle. In cases where a top corner marking is not possible due to the construction of the vehicle, a line marking on its own is allowed. To the rear: Here a full contour marking is required, i.e. a full 'box'. This can be either in red or alternatively yellow

Affixit offers 4 standard grades of reflective tape, these are Engineering Grade, Class II, ECE104 Conspicuity Tape and Chapter 8 Reflective Tape. High Visibility Reflective Film is engineered to improve the day and nighttime visibility of emergency response, utility, and construction fleets. It is built with solid construction instead of air-celled construction like other brands. Solid construction is more durable and long-lasting . Highly reflective vehicle markings can improve detection and recognition, giving drivers more time to react safely and avoid a collision. Collision avoidance may help fleet managers contain costs through lower repair, maintenance, and insurance fees. It offers durable, vibrant daytime colours. At night, its bold, high-quality microprismatic retroreflective elements efficiently return light at a wide range of angles. The single-layer construction simplifies application and eliminates the requirement for edge sealing. Fluorescent colours have a durability of 5 years whilst non-fluorescent colours have 7 years.

Avery - For Flexible Surfaces

If you need Reflective Tape for HGVs over 7.5 tonnes and trailers over 3.5 tonnes, you must use ECE104 Reflective Tape. Left & Right Hand To the sides: Here you can choose to do either a full contour ('box') marking, or a line marking of the length of the vehicle plus marking of the upper corners if the design of the vehicles allows for this (Partial contour). It is a good idea to mark also the tractor (e.g. on the door) to visually get a marking of the full length of the vehicles, however this is not an obligation. It is the customer’s responsibility to determine if the tape will be suitable for their use and the material it’s adhered to. We take no responsibility for any damage from the removal of the tape or if the tape doesn’t meet the regulations required for a customer’s specific use.

Affixit’s Engineering Grade Reflective Tape is an economy reflective tape enclosed lens retroreflective sheeting. It’s intended use is on signing applications that require the durability to be up to 2-years, including traffic signs, advertising graphics, or promotional signings. It is made with a polyester face film, so that the sheeting is strong and rugged for demanding short-term signing applications. Furthermore, it is supplied with a permanent pressure-sensitive adhesive and an easy-release paper liner. Class II Reflective Tape - 10-Year Durability The Hi-Vis Yellow Self-adhesive Reflective Tape helps to improve day and night visibility. It is ideal for increased visibility in low-light conditions. The 3M™ Scotchlite™ segmented yellow-silver-yellow reflective transfer film 5637 with an exceptional design for safety clothing, such as firefighting garments and flame-resistant workwear, requiring a high degree of daytime and night-time visibility.

Avery - For Rigid Surfaces

It is your responsibility to make sure that you comply with any applicable laws, and that you buy the right tape for your intended use.

If you need Reflective Tape for HGVs over 7.5 tonnes and trailers over 3.5 tonnes, you must use ECE104 Reflective Tape. Application The Hi Vis Yellow Reflective Tapes can be used for Bicycles, Fence Posts, Car Doors, Driveway Posts, Letterboxes, Steps, Low Hanging Objects, Ledges, Exits & Entrances etc. Performance may vary depending on factors such as temperature, humidity, surface conditions, and installation techniques. We recommend conducting thorough tests and evaluations to ensure the tape meets your specific requirements before full-scale application. Use on VehiclesReflective tape is made from reflective vinyl which is then coated with a pressure-sensitive adhesive before being converted into standard and bespoke sized rolls, sheets or gaskets. If you need Reflective Tape for HGVs over 7.5 tonnes and trailers over 3.5 tonnes, you must use ECE104 Reflective Tape. Ensure all surfaces are clean, dry and free from dust, grease and dirt prior to application. Ensure the ambient temperature is within the range specified in the application temperature (refer to the technical data sheet for this information). Once in situ apply pressure to the tape to ensure maximum ‘wet out’ of the pressure-sensitive adhesive).

The construction of each of these tapes differs, this results in different levels of reflectivity and durability. The 3M™ Scotchlite™ segmented yellow-silver-yellow reflective transfer film 5637 was developed for safety clothing, such as firefighting garments and flame-resistant workwear, requiring a high degree of daytime and night-time visibility. The retroreflective part of the trim shines white when illuminated, even if the wearer is at the roadside. The product is characterised by a high degree of heat resistance and outstanding durability during use. 3M's segmented reflective transfer film consists of high-performance glass lenses. The reflection values of the silver trim meet ISO 20471 requirements. In addition, the yellow trim ensures daytime conspicuity. Together, they improve the visibility of people during the day and at night. The flame-retardant properties of the garment meet EN 469 flammability requirements. It offers good product quality for fire and flameproof protective clothing washed at home. The segmented reflective transfer film with a high degree of wear resistance and durability is easily washable at 60°C at home (30 cycles as per ISO 20471). The reflective transfer film is assimilated through lamination and is thus permanently bonded to the garment without adding bulk. Because of this, it offers improved wear comfort and is also suitable for garments with membranes. The reflective trim has an unusual appearance, thus ensuring a high degree of recognition. It is available in two different widths. Another advantage: Segmentation ensures better comfort and increased breathability. In addition, the retroreflective properties of the material are independent of the grain on the garment and achieve a good impact even when wet. This means good visibility is ensured for many angles of incidence and even in poor weather conditions. The patented glass bead technology of 3M ensures a very textile appearance, making the fabric flexible and light and creating a high degree of wear comfort. Although this tape is very effective it is not graded, so if you need a particular grade or specification such as for highways this tape is not suitable. Sizes

Asda Great Deal

Free UK shipping. 15 day free returns.
Community Updates
*So you can easily identify outgoing links on our site, we've marked them with an "*" symbol. Links on our site are monetised, but this never affects which deals get posted. Find more info in our FAQs and About Us page.
New Comment