About this deal
Tuya ZS3L module has a circuit board antenna while the smaller Tuya ZSLC5 have fewer IO pins and does not have an antenna so needs an external antenna via pin 1. Info 2022-08-31 08:17:12Successfully interviewed '0x00158d000894fa97', device has successfully been paired Debug 2022-08-31 08:20:39Received Zigbee message from '0x00158d000894fa97', type 'attributeReport', cluster 'msIlluminanceMeasurement', data '{"measuredValue":94}' from endpoint 1 with groupID 0
In addition that are some hints the same module (or just a similar module) is maybe also used for Bluetooth in their Convexa-S (GL-S1300), Velica (GL-B2200), Cirrus GL-AP1300 / GL-AP1300LTE AC1300 Ceiling Wireless Access Point(?) and perhaps even more of their other products:Available real-world products are example the different Tuya Zigbee Smart RGB and RGBCW LED Controller for 5V-24V Light Strips
If some one like to knowing more way Sonoff ZBB is having so much problem (not only the SM-011 module is bad) shall reading this KB: AN1017: Zigbee® and Thread Coexistence with Wi-Fi. I’m sure others can offer an opposing anecdotes. I can only report my experience. I suspect the intricacies of what makes one chip perform better than another may be largely dependent on the specific environment/device mix. SM-011 module provides gateway transparent transmission serial port and OTA upgrade control interface. SM-011 module supports IPEX external antenna and PCB onboard antenna. and then press the "RST." button (lower button in the lower right corner next to the USB plug in the photo below) to restart the device
EFR32xG24 Wireless 2.4 GHz +20 dBm Radio Board
Wondering if this CC2652P serial port will have pins connected for RTS / CTS Hardware Flow Control?
ZHA: Unable to Pair Devices w/ ITEAD Zigbee 3.0 USB Dongle · Issue #48592 · home-assistant/core · GitHub Launch command-prompt (cmd.exe) as elevated Administrator. Upgrade pip with python -m pip install --upgrade pip, (if pip is not available then first run python -m ensurepip --upgrade), then pre-install dependencies fro cc2538-bsl from PyPi via pip command: pip install wheel pyserial intelhex python-magichttps://community.arm.com/developer/ip-products/processors/trustzone-for-armv8-m/f/trustzone-armv8-m-forum/8338/what-is-the-top-level-difference-in-features-between-cortex-m33-and-cortex-m4
![Asda](http://magento-forum.co.uk/777/templates/hotukdeals/res/23958_2.jpg)