V23074-A1001-A402 12V 4PIN PA66-GF25

Product Information

Flame retardant and dielectric properties of glass fibre reinforced nylon-66 filled with red phosphorous. All these properties make this material suitable for use in parts which are exposed to high static loads over long periods in high temperature conditions. The Western Union Company is a financial services and communications company based in the United States. It can also be seen that differences between the “DD T” and “DD L” for samples treated by route I without a “supporting mold” are the largest, and the values of “DD T” and “DD L” for the undried or dried parts are all out of the tolerance ranges. Thus, after the treatment, the size of the undried parts expands to be much closer to the nominal size.

Ensinger offers glass filled nylons to meet the specific needs of the different areas of application.

Tensile behavior of thermoplastic composites including temperature, moisture, and hygrothermal effects. By combining the dimensional measurement, mechanical property test, and micro-morphology analysis, the transverse and longitudinal dimensional accuracies and the mechanical properties of the plate treated by the three treatment routes were compared and analyzed. The influence of environmental conditions on the dimensional stability of components injected with PA6 and PA66.

Annealing effect on crystalline structure and mechanical properties in long glass fiber reinforced polyamide 66. Its North American headquarters is in Meridian, Colorado, though the postal designation of nearby Englewood is used in its mailing address.Compared with the values before the treatments, Figure 8 and Table 3 show that the tensile strength and bending strength of the dried parts treated by route II increased by more than 141. Kinetic of crystallization from the melt and chain folding in polyethylene fractions revisited: theory and experiment. It can be seen that the mechanical properties of the plate have been significantly improved after the boiling water bath. From the aforementioned comparisons, it can be concluded that the dimensional accuracies of the undried parts treated by route II are the highest for the peripheral dimensions and the diameter of the central hole.

However, at the same time, the mechanical property of the plate is found to decrease by 50%, as presented in Table 3, which is mainly due to the internal residual stress caused as the linear shrinkage is hindered by the “supporting mold.Non-isothermal crystallization of polyamide 6 matrix in all-polyamide composites: crystallization kinetic, melting behavior, and crystal morphology. This phenomenon is caused by the different longitudinal and transverse linear shrinkage due to the anisotropy of the composite [ 11] determined by the flowing direction during the injection molding process. While we have placed significant efforts in ensuring data accuracy, "typical" and "predicted" data should be considered indicative and verified by appropriate material testing.