Hinge Stand Kit for Painting and Spraying Doors | Reusable Door Stand | for Professional Painters, Contractors, Homeowners and DIY | Holds up to 8 Doors

Product Information

Taking the time to properly prep your door with primer and sandpaper while using high-quality exterior paint can also be beneficial. With these tips in mind, troubleshooting any painting difficulties can seem much less daunting! Conclusion Our Hinge Stand kit holds up to 8 doors and contains 4 Hinge Stands & 16 floor spacers. For tall & heavy doors, use 2 hinge stands per pair.

We needed a product that could help us to paint all those doors and trim in a small space and there was nothing on the market to facilitate. Once we experienced how well it worked out for us, we shared it with others. Before long an ever growing demand ensued. The setup uses a couple of sawhorses, some long screws, and a few pieces of plywood to make a spinner for supporting a door while it is painted. There are several factors to consider. 'By painting doors a darker color than the wall, you can make a strong feature in the home, and it looks very effective in larger spaces where some contrast is quite important to make the space feel cozier,' says Kashi.If you’re looking to freshen the look of a door in your room, then prepping the door for painting is an important step. First, use a putty knife and remove any peeling paint or chipped areas. Next, sand down the entire area until it’s completely smooth to the touch. Then clean off any dust with a dry cloth and finally apply painter’s tape carefully along both sides of the door frame you don’t want to be painted. Applying Primer You are ready to set up your doors for painting. Even if you decide to roll or brush paint the doors, this setup is still a good idea because it will hold your doors upright while you paint and allow the door to dry. For most people, painting isn’t such a fun job. It can be messy, and is a whole lot of work. What we have found is that proper setup can alleviate a lot of pain and stress during the painting process. We want to show you how to set up doors to be painted, so that when you go to actually paint the doors, the process goes smooth and fast. Setup will take some time here, so be prepared. I assure you it will be worth it in the end.

Also, if the door itself is a wonderful design feature with ornate detailing, moldings, and more, you can highlight its beauty by paintings its surface in rich, deep colors. First, we tie a couple of sawhorses together with a 2×6 screwed to their crossbars. Then we screw a plywood upright to each crossbar. The uprights have notches in their top ends, as shown in the drawing. Concrete-screw axles centered in the ends of the door ride in the notches, allowing the door to be rotated for painting both sides in the same session. Make sure that the uprights are tall enough to allow the rotating door to clear the 2×6 cross tie. This is also a good way to bring attention to your home's architectural features. Have a pitched roof above the door? Wonderful crown moldings? By painting the door, you encourage people to take a look at the entire height of the room, along with the features above it.

To ensure maximum protection from the elements, it’s best to apply an exterior-grade sealant that can stand up against wind, water, and sun exposure. Regular maintenance will also greatly increase your front door’s durability and help keep its beautiful look for years to come! Tips for Maintaining Your Painted Front Door Over Time Brushed paint usually levels out better than rolled paint, and any brush marks are less noticeable than roller stipple. Painting a door with a roller can seem like an intimidating task, but it doesn’t have to be! The key to achieving a smooth, even coat is all in the preparation. Before beginning, make sure all surfaces are properly sanded and wiped down using a clean cloth and then allow them to dry thoroughly. The PSDR Series is an integrated system that uses cabinet door hangers for painting. It's designed to paint and dry cabinet doors in a vertical orientation with the least amount of effort and space. Cabinet door hangers are used for spraying all sides in one step.