Sikkens Rubbol Satura Plus- White 5L Litre Fast Postage

Product Information

Sikkens Rubbol Satura Plus is a solvent based, satin finish for exterior and interiors joinery and suitably primed metals and hard plastics. It’s a durable paint with excellent opacity giving even coverage and protection on joinery for up to 5 years. A flexible formula that resists peeling and flaking. Can be used as a two part system with Sikkens Rubbol Primer. To ensure optimum durability, we recommend the use of a coat of Rubbol Primer plus prior to finishing. Rubbol Satura Plus: - can be used to give a stylish and long lasting opaque satin finish to exterior doors and windows. What is more, although it is primarily designed for exterior wood, Satura plus is a versatile finish than can also be used as a finish coat on suitable primed metals and hard plastics. Base stained/primed : Denib using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicon carbide abrasive paper, in the direction Tinted colours cannot be cancelled or returned as they have been mixed to your specific requirements.

Second coat must be applied within 48 hours to provide full protection, if not applied within 48 hours light sanding with a medium grade abrasive, to provide a surface “key” will be required, ensure all dust is removed. to acclimatise to its end-use environment. The moisture content should not exceed 18% prior to coating.Degrease any exposed bare timber surface by wiping with a cloth dampened in a suitable solvent. Certain timber species contain All damaged or decayed timber must be removed and replaced, cutting at least 25mm into sound timber

Pallet agreements which are about to expire

Note: Where there is localised damage, or deterioration has occurred as a result of exposure of the factory coating for longer

addition, the adhesion of coatings can be impaired.When filling, be sure to use fillers specifically designed for use with timber. General or all purpose fillers are not suitable, particularly on external areas, as they cannot cope with timber movement and work loose. Where a superficial application of preservative to softwoods and hardwoods is deemed necessary, be sure to only use wood preservatives that do not contain wax or silicone Knotting may be used to reduce extractive discolouration, however, knotting is not always fully effective in “sealing in” resin. In Two coats of Rubbol Satura plus should be applied, allowing a minimum of 18 hours drying time between coats. On new work,Denib (lightly sand) using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicon carbide abrasive paper, in the direction of the grain Timber surfaces to be treated must be clean, dry, and free from all traces of dust, dirt, wax and grease. The moisture content of the timber must not exceed 18%. This figure will be 14% or lower for interior timbers. New or Bare Timber If applied to exterior wood and the contract is of long duration, it is suggested that a further coat be applied prior to hand over to make good any weathering during the construction period. Before applying stir the product thoroughly and test a small area to ensure colour and adhesion. Colours can vary dependant on surface to be treated.

If the second coat is not applied within 48 hours, light sanding with a medium grade abrasive, to provide a surface “key” will be required. Degrease any exposed bare timber surface by wiping with a lint-free cloth dampened in methylated spirit Conditions: Do not apply if there is a risk of rain, or when air/substrate temperatures are below 5ºC or above 30ºC during

Knotting may be used to reduce extractive discolouration, however, knotting is not always fully effective in sealing in resin, and the adhesion of subsequent coatings may be impaired Failure to meet these requirements may adversely affect the drying, visual quality and durability of the finish.