About this deal
At this time, turn on your device’s Bluetooth and look for SESH® EVO in your list of Available Bluetooth devices. Please make sure it only appears once, and select it.
You’ll know you’ve got it right when you hear bass that feels full, not hollow. Keep trying until you get there. Both buds will automatically power ON and the LED’s will simultaneously flash BLUE while they sync to each other. After you’ve found your Tile, tap the blue “Done” button or press once firmly on the Tile button to make your Tile stop ringing. For the optimal Mono Mode functionality, first Power On and pair your buds to your device normally or as described in our troubleshooting section. This will ensure the seamless transition between Stereo and Mono modes.The most critical thing is to get a good seal with the available eartips. Without this, the earbuds will sound downright dreadful — both hollow and tinny. Skullcandy ซึ่งหากยังไม่ถูกใจก็สามารถปรับเปลี่ยน EQ เสียงได้อีกถึง 3 แบบได้แก่ เพลง, หนัง และ Podcast ซึ่งจะให้แนวเสียงที่เหมาะกับกิจกรรมนั้นๆ สำหรับเสียงโดยรวมจะคล้ายๆ กับในรุ่น INDY EVO โดยจะออกแนวเบสแน่นกว่าลงได้ลึกตูมตามกว่านั่นเอง You also have access to three EQ modes, for music, movies and podcasts. Movie mode, for example, boosts the bass and volume while Podcast mode takes out a lot of the bass. Music is its basic setting. You can also pull up a smart assistant through the Indy Fuel as well. Once linked to the Skullcandy App, scroll down to the widgets and set up Personal Sound for your optimized listening experience. Issue: The biggest challenge with true wireless earbuds is maintaining a paired status between both independent buds. There are times when the user will intentionally or unintentionally modify the connected states of the SESH® Wireless buds, this can create a pairing challenge as both the LEFT and RIGHT SESH® Wireless buds because they would then be in different pairing and search modes when powered on. This is an easy fix!
Place them in the charging case, and make sure the LEDs on both earbuds turn red, then close the case. The button mechanism sits under a membrane, which keeps them safe from dust and water, but it also makes them harder to press. After some trial and error, I found the easiest way to use them was to press a finger against the membrane, then press a little harder until it triggered the mechanism. It’s kind of like the press-halfway-to-focus system on camera shutter buttons.Please make sure you have enabled Bluetooth permissions in the app. If you have declined Bluetooth permissions you may have to go into the app settings and re-enable.