Joined in 2023 
82 
63 About this deal
Installing the Flowflex Inline Micro Pump is easy business. Any DIY enthusiast can do it themselves, or call on a professional.
As an aside, due to the immense pressure being put out by this pump I am tempted to re-place the pump so that it is connected right after the hot water cylinder so that it boosts the pressure to all hot water taps around the house. The SPB is future-proofed and can be replaced and repaired by the customer, or upgraded as new models come along, by simply screwing out the old motor or barrel and screwing in a replacement.Shower pumps are relatively small, usually measuring around 30cm in length. They can be both larger and smaller than this, but the size you go for will depend on the type of shower you have as well as the space you have available. The Flowflex In Line Micro Pump is a universal pump meaning it can be used in positive and negative head situations. Negative head pumps are where the pump is placed level or above the cold water tank. This draws water from the tank to pump into the shower at a higher pressure. Single vs Twin Impeller System CT Bathroom pumps have been designed specifically to meet the demand for increased water supply to the bathroom. With positive head and negative (universal) head models available in 1.8 or 2.6 The Flowflex In Line Micro Pump advises that it can be used before or after a Combi boiler. Before to boost the entire home, or after to support up to 3 underperforming taps and showers. Compatibility with Fortic and Close Coupled Tanks
Link multiple vessels together to increase performance. Only one vessel should be a pumped model in this scenario. A ShowerPowerBooster is a very quiet retrofit in-line power shower which power boosts taps and showers (as seen on Dragons Den.) It solves low water pressure by increasing and regulating pressure without major changes to your plumbing. It is suitable for gravity systems, electric showers, combi-boilers, and all other pressurised systems, central heating radiators, boreholes, and solar thermal tanks. It is unique in the world with a UK Patent granted and is exported worldwide. It is WRAS Approved, and was invented by Alan Wright BSc(Hons) CEng MICE. If there is air trapped in the pipes you’ll need to bleed your pump. To do this, turn off the electrical supply and allow water to run out by removing the shower head from the hose. Allow cold water to run for 5 minutes, then turn the temperature to full hot and allow this to run for a further 5 minutes.
Shower pumps come as both negative and positive types, and what you go for will depend on your water system. Positive head pumps are fed by gravity. These pumps usually need at least a meter between the bottom of the cold water cistern and pump. Gravity starts the pump which then raises the pressure of your shower. Once you’re certain there’s no leaks, you can reconnect the wires and turn on the electrics. How to bleed a shower pump?
The CT Range of shower pumps have a regenerative impeller. They are long-lasting, hardworking, compact, and easy to install. Inline shower pumps are an essential component for those seeking to enhance their showering experience with a reliable and efficient water pressure system. Designed to boost water pressure in low-pressure plumbing systems, inline shower pumps ensure a steady flow of water, providing a refreshing and invigorating showering experience.If you're in big trouble and have a flow rate lower than this, there is an option to bypass the automatic setting and have the pump running continuously on manual, ready for any flow rate. Which one do I need for positive head situations? Here at PlumbHQ, we don’t want to be your average online plumbing supplies retailer. We have several goals that we always aim to achieve. Not only do we always aim to offer the highest quality products at the lowest prices, but we are also committed to encouraging environmental and social responsibility on behalf of our customers and our manufacturers.
Great Deal 
New Comment