276°
Posted 20 hours ago

ESI ES2247B 2-Channel Multi Purpose Programmer (New Model)

£123.495£246.99Clearance
ZTS2023's avatar
Shared by
ZTS2023
Joined in 2023
82
63

About this deal

Binding can be done with either a hard-coded unique Binding Phrase or in a more traditional way where you put the receiver and transmitter into bind mode, and they link up. Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie.

Disconnect the RX and TX wires of the Receiver from the Flight Controller. Reconnect power to the drone or aircraft. Observe the LED on the Receiver once again. The ESi Controls 2 Channel Programmer offers flexibility and reliability for use in any domestic heating and hot water installations. The ES2247B is a twin channel multi purpose programmer, designed for separate control of your heating and stored hot water. The heating and hot water programmes are independent of each other, giving you the opportunity to operate the system in the most energy efficient and cost effective manner. If it starts Blinking Slowly (500ms Blink Pattern), you will need to move the receiver wiring to a different UART. It is designed primarily for separate control of your heating and stored hot water (S or Y plan). The heating and hot water programmes are independent of each other, giving you the opportunity to operate the system in the most energy-efficient and cost-effective manner. a Receiver with version string of 3.1.2 will sync and work with a TX Module with firmware version 3.0.1SPI-based Receivers on (official) Betaflight 4.3.1 and older will only sync or bind with ExpressLRS 2.x firmware

If you are using any of the Digital FPV systems like the DJI FPV Air Unit, Caddx Vista or DJI O3 Air Unit, and you wired or connected all six wires to your Flight Controller, you will need to remove the SBUS/DJI HDL wire. With the release of ExpressLRS v3.0, updating your Binding Phrase via the WebUI is an even more compelling reason to use a Binding Phrase. If the ExpressLRS Lua Script is showing a C in the top-right corner alright, but then that line disappears and is replaced with a line saying "Model Mismatch", do not worry. ExpressLRS has detected that the set Model ID in the Receiver is different from the Receiver ID set in the current Model in your Radio Model Configuration. SPI-based Receivers on Betaflight 4.4.0 and newer will only sync or bind with ExpressLRS 3.x firmware

If the other UART is occupied by another peripheral, disconnect it and swap places with the Receiver. The ES2247B is a two channel multi purpose programmer with the flexibility of two or three on/off timings per day and can be configured for 7 day, 5/2 day or 24 hour operation for independent channels (all within the one unit), allowing one product to suit all installations alleviating any potential of incorrect selection. a TX Module with version string of 3.2.0 will NOT sync or bind with a Receiver with firmware version 2.4.0 However you say "Turned the thermostat right down but heating stayed on." which does not seem to point to the programmer.

Asda Great Deal

Free UK shipping. 15 day free returns.
Community Updates
*So you can easily identify outgoing links on our site, we've marked them with an "*" symbol. Links on our site are monetised, but this never affects which deals get posted. Find more info in our FAQs and About Us page.
New Comment