12pcs Pool Plug Stopper Compatible with Bestway & Intex Swimming Pool Wall Plugs Replacement Parts Above Ground Swimming Pool Filter Strainer Plug Stopper for Inflatable Pool Accessories

Product Information

After setting the run time, the pump will restart automatically at the same time the following day. IMPORTANT: Certain types of hard grass can grow through the liner, as can aggressive bushes/plants by the sides or through the pool. If this happens, it cannot be considered a manufacturer problem. IMPORTANT: cover the hole on the top of the hub to avoid the sand going inside, and add the sand gently to avoid damaging the debris screen at the bottom of the tank.

Open/unscrew the Air Purge Valve on the top of the Filter Pump; air is released as water fills the Filter Pump.Circulate: This function circulates pool water bypassing the sand filter. Use this function if the filter is broken to collect debris in the debris screens. NOTE: Atmospheric conditions may affect the performance and life span of your filter pump. Unnecessary wear and tear may occur during periods of cold, heat and exposure to sun. Whenever possible shelter the pump from these conditions. Using the pump with an unmatched electrical supply is dangerous and will result in catastrophic failure of pump. IMPORTANT: when performing this operation, please be sure that the O-ring is in the correct position and completely clean from the sand. Filter: This function is used to filter pool water and should be positioned here 99% of the time. Water is pumped through the sand filter, where it is cleaned and returned to the pool.

Any field modification made to a SOFA not authorized by the manufacturer's installation instructions shall void the SOFA certification. Pushing the test button on the GFCI does not stop the timer. To stop the timer, you have to unplug the GFCI. After finishing the working time, the GFCI goes into stand-by mode. During this time, all LED indicators will be off. Do not dry run the filter pump. Make sure both the pool's Inlet and Outlet valves are fully covered by water before operating the Filter Pump. POOL SUCTION FITTING INSTRUCTIONS

SOFA components and fastener receptacles shall be clean and free of debris or obstructions during installation of cover/grate and fasteners.

USE ADAPTOR PLUGS. Consult a qualified electrician for any questions related to the validity of your plugs grounding. Handle the pump with care. Do not pull or carry the pump by the power cord. Never pull a plug from the outlet by yanking the power cord. Keep cord free from abrasions. Sharp objects, oil, moving parts, and heat should never be exposed to the filter pump. No modification shall be made to a SOFA structure or flow path unless the new configuration has been certified to the original SOFA.YOU MUST ENSURE THE FILTER PUMP IS UNPLUGGED BEFORE ANY MAINTENANCE BEGINS OR SEVERE RISK OF INJURY OR DEATH EXISTS. Seventh step: fill the bottom part with the new sand until it reaches the mark between low and high marked on the hub. Installer need to fill in the balance of information and give it to the pool owner, to be kept with other important pool related documents.

Each LED indicator represents 2 hours of working time. You can push the Set Working Hours Button to adjust the desired time. When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: Winterizing instructions. Dry the suction fittings completely ,and store the product in a dry room at a storage temperature of 15 ℃; ~ 40 ℃.Before inserting plug into a power outlet, make sure the current rate of the power outlet is suitable for the pump.