Silverline Pipe Bender Guide 15mm (MS124/15)

Product Information

When Monument look to design, manufacture and market a new product we look to create products which will save the engineer time. In this particular instance, we have designed a smaller and lighter weight pipe bender than the standard combination 15and 22mm hand bender. The Monument 2600K 15mm and 22mm is a best selling pipe bender. These are available in Monument brand widely available across the UK from plumbers merchants and e-tailers MON2600 2600K, Instinct® brand INST2600 from PHG independent plumbers merchants and also from UKPS plumbers merchants including Plumbase under Entity® brand ENT2600. When initially launched on the UK market Monument ensured that the hook stop was redesigned so as to not mark the pipe.

The Monument Masters 1215K, 1315XVE (replacing the 1315Longarm ), 1222G and the 1322Extended Pipe Bender are #MadeInBritain. First models of the new pipe bender were designed and 3D printed in the engineering suite at Monument. We standardised the handle diameters for both sizes. The 15mm pipe bender also known as tube bender is an essential part of the toolkit for any heating or plumbing engineer. Pipe benders come in a variety of sizes catering for copper pipes from 6mm to 38mm and are operated by hand. Mechanical benders deal with pipes bigger than this.lighter in the hand than a combi. The Monument combi weighs more than 4kg; the XV weighs 1.5kg; the XXII weighs 2.3kg throating occurs on testing with the XV, XVE (XVL) XXII, XXIIE as well as Monument 2600K and a Hilmor® GLM less fiddly– with the integrated hook and nylon guide, your hook stop won’t flop from side to side and the guide(s) won’t fall out The single sizes of each bender with their shorter bending arms and lightweight aluminium die casting makes each bender lighter to carry and the design of the 15mm-XV is small enough to fit inside a toolbag.

better sight lines– as the bend is in the same plane as the Arms of the bender it is easier to line up by eye pipe, bent with a spring is ok, but do not expect a very tidy job and read our project about how to box the pipes in afterwards as although it will probably do the job it will need hiding away! Within this area you will find a great deal of information including how to pull 90 degree bends with 50mm offset bends at 30 degrees allowing you to bend round vertical pipe runs with a horizontal pipe run you are placing.XV is much smaller than a combi; arm length is 40cm compared to a combi arm length of 65cm. Note the 15mm XVL & 22mm XXII arm lengths are about 60cm Before you remove the pipe from the Former, view your bend angle; remove the pipe if it is correct, or if necessary, reapply the Lever Arm and increase the bend angle. Frequently Asked Questions FAQs A. Cheap thin copper but even expensive copper ripples. But makes a big difference with running wire wool over the guides first. Keep them clean. Found the wee monument benders don’t ripple the pipe as much. Great wee benders (Answered by Roy Millar Plumbing and Heating on 26 Jan 2021)