Lucas Oil 10001 Heavy Duty Oil Stabiliser, 946 ml

Product Information

I own a 1995 Olds Cutlass Supreme, 3.1 liter engine. At 188,800 miles, both the intake manifold gasket and a head gasket leaked coolant. I thought it was leaking out the rear of the engine onto the exhaust manifold and evaporating. It turned out to be an internal leak. I drove the car for several months, adding up to 9 gallons of antifreeze/water until I decided to take the engine apart. When I removed the valve covers, there was foam and I found an emulsion of 5W-30 Quaker state oil, Lucas Oil Stabilizer, ethylene glycol antifreeze and water in the oil pan. It can solve several issues of your vehicle’s engine, like oil leaks and unwanted noise. Also, it can solve some transmission issues like slipping. In simple words, yes, users get benefits by using Lucas stabilizer. I take care of 6 cars and put in one quart of Lucas Oil Stabilizer at each oil change. The engines run smoothly and quieter with the Lucas oil than with only all regular oil. You can actually tell the difference in the running of the engine prior to the oil change and after the oil change with the Lucas oil additive. I have convinced several relatives to add Lucas oil at each oil change and will continue to advise anyone I speak to about cars to use Lucas oil with each oil change.

According to the official instruction of Lucas, you can apply the stabilizer in great quantities for the latest new vehicles if needed. By all means, the engine should have blown (spun bearings, etc). It didn't. The engine continued to run smoothly, even when it overheated. I have cleaned and rebuilt the engine and it continues to run very well. Start testing it depending on some products! Below I recommend two higher qualities of Lucas oil stabilizer products that are reliable and certified by most users as the best oil stabilizers. Let’s see why they are good?In engines: Use approximately 20% or one quart to each gallon of any plain motor oil. Petroleum, or synthetic. They were tested on-road on the road and gave a lot of hard data that proved that Lucas oil stabilizer is good for the engine. How To Use Lucas Oil Stabilizer? Know The Basic Ratios

In my opinion, the Lucas oil additive coats the parts very well, does not wash off the parts either with time or temperature and acts as an excellent lubricant as it is pumped throughout the engine. In Ford Powerstrokes, it is recommended to use one quart of Pure Synthetic Oil Stabilizer per oil change. For this, the Lucas oil stabilizer review will help you decide whether it will provide better performance. First, it increases the engine life 50% longer, and the 100% petroleum product formulated to reduce friction and heat of any engine Many users are afraid to use aftermarket additives due to the snake oil additive. So, you might have been confused about using the Lucas oil stabilizer.

Lucas produced a motorcycle oil stabilizer, especially for a motorcycle engine. It controls the heat and wears even in high-performance motorcycles. It is excellent for decreasing friction and increasing compression to increase fuel mileage. The locus additive will take 15 to 20 minutes to start working after you add it to your transmission. In a short time, it will fully blend with the fluid almost immediately. The formulation of Lucas oil stabilizer is produced in that way so that you can use it in your new car.