TP-Link AX1800 Wi-Fi 6 Dual Band Gigabit Ceiling Mount Access Point, Omada Mesh, Power over Ethernet (802.3at) or DC, Easily Mount to Wall or Ceiling, Free EAP Controller Software, Easy use (EAP610)

Product Information

Yes. Requiring the use of Omada Cloud-Based Controller (Supported by EAP610 V1, V2, V2.2 and above, while is not supported by EAP610 V3)

Yes. Requiring the use of Omada Cloud-Based Controller (Supported by EAP610-Outdoor v1.20 and above, while not supported by EAP610-Outdoor v1.0). What's the difference between the Master Administrator, Administrator and Viewer accounts in the Omada Controller? 04-12-2023 15127Switching to the first WiFi 5 client device, the laptop equipped with the Intel 8265 adapter, the WiFi performance was very similar to that of the EAP610-Outdoors. This means that I measured 537Mbps up and 313Mbps down at 5 feet, while at 45 feet, the speed was 215Mbps upstream and 119Mbps downstream.

Some official firmware of TP-Link products can be replaced by the third party firmware such as DD-WRT. TP-Link is not obligated to provide any maintenance or support for it, and does not guarantee the performance and stability of third party firmware. Damage to the product as a result of using third party firmware will void the product's warranty. Open Source Code For Programmers (GPL)Using Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 07-07-2023 15398 To avoid wireless disconnect issue during firmware upgrade process, it's recommended to upload firmware with wired connection unless there is no LAN/Ethernet port on your TP-Link device. I saw that the TP-Link EAP610 has the same antenna gain as the EAP610-Outdoor and I admit I expected less from the indoors AP, but no, you get the same 2x 4dBi antennas for the 2.4GHz radio and 2x 5dBi for the 5GHz radio band. So don’t forget to reduce the transmit power for the 2.4GHz radio unless you want interference with your neighbors. Lastly, the TP-Link EAP610 has support for the TP-Link mesh implementation, but it’s not compatible with OneMesh (for reasons unknown to me). You can only use it with other Omada access points. Wireless Test (5GHz) Zero-Touch Provisioning requires the use of Omada Cloud-Based Controller. Note that EAP610-Outdoor v1.0 doesn't support Omada Cloud-Based Controller.Please go to www.tp-link.com/omada-cloud-based-controller/product-list to confirm which models are compatible with Omada Cloud-Based Controller.