Tableau Red Tile Polish, Rejuvenate Red Tiles, Brickwork, Unsealed Concrete and More. 250ml

Product Information

The hero of this restoration is the Lithofin Tile Restorer because it does exactly what it says on the tin. A lot of the surface grime will come up immediately with this but I did find that the more stubborn areas of ground-in dirt and paint took a little longer. So this is how I did it. For instance, in our living room downstairs, I took the decision to paint over the tiled hearth (which were exactly the same tiles you see above) as they just didn’t work with the colours we had in the living room and as I was already re-painting the fireplace tiles, I figured I’d do those at the same time.

Now I’ll just start by saying while the product works really well, it does entail a little bit of elbow grease. For this small area, I would say it probably took me around 30-40 minutes which is fine when you’re dealing with only a small group of tiles in a hearth but you will probably need to set aside a lot more time for this if, for instance, you are dealing with a hallway or large room of original Victorian tiles. When the old vinyl flooring was ripped up, I was overjoyed to see there was actually a tiled hearth hiding beneath. I was delighted because I knew these would have been the original tiles that were laid 130 years ago when the house was built. I’ve seen these particular tiles in my home in a few different locations – they are the same tiles we have on the steps outside the front door and they were also used in the hearth in our living room.Then move on to the next section of tiles and the next in the same way until they are all clean. Step 5 Once everything has been lifted up, use the sponge cloth (again dipped in the clean water and rung out) to run over the tiles you’ve just cleaned and remove any remaining tile restorer residue from your tiles. Anything of a nature that for hygiene or associated health and safety - this includes the Outdoor Spas, Mattresses and Divan Sets As this point, I found the paint would start to soften a bit and for any stubborn bits, I used the scraper to gently lift the paint from the tiles and then I’d use the scrubbing brush for anything that remained. Step 4

Scrub the area well with the tile restorer and leave to set for a few minutes. Use the sponge cloth dunked in the clean water, ring out to remove the excess water and wipe the area to remove the top layer of grime. This is not intended to be a full statement of your rights under the Consumer Contracts Regulations. Full details of your rights are available from your Local Authority’s Trading Standards Office. How To Return A Product As you may be aware, I’m still beavering away on renovating my combination office/dressing room but I just had to share this little DIY update with you because I couldn’t believe just how easy it was. In the room, I have this tiny corner Victorian fireplace – it isn’t a working fireplace but it’s just so sweet and special that I knew I wanted it to make the best of this original feature in our old house.Tip the bottle directly onto your scrubbing sponge (or a small amount on the tiles if you are using the scrubbing brushes) and start working the liquid into a small patch of tiles at a time. I found it was best to concentrate on only two or three tiles at a time and work my way around. Step 2