Aqualisa Pinch Grip sliding handset holder - 25mm - Chrome/Grey

Product Information

How do you fit the replacement holder? Mine has broken and the only way to replace it is to slide it onto the pipe, but how? What needs to happen? Dismantled from top or does controller at bottom of pipe come off? Concealed control - On the underside of the control, you will see a single self-retaining screw with a cross-head – loosen the screw to release the securing end cap. Don't know why someone hadn't thought of it before, but the new handset holder is absolutely brilliant. It was so easy to fit and it should last year's, not the short time that other holders have survived. The service from Pumbworld was pretty in good too.

The appropriate hot water flow regulator will need to be fitted in the hot inlet of the valve. 3 regulators are available dependent on the KW rating of the boiler. If not due to the above, the issue will be related to the micro switches which may need to be replaced... Bath control (horizontal orientation) On the right of the control you will see a single self-retaining screw with a cross-head – to release the control.

Flow & Leak Questions

Our original Aqualisa pinch grip had worn out after many years & shower head was slanting downwards

PRVs should feature as part of the installation and generally operate at 2-3 Bar of pressure. If you are experiencing an increase of pressure on an unvented installation, this could indicate that the air gap inside the tank needs servicing. This would need to be assessed by a plumber qualified to work on unvented tanks. Do you have a question about the Aqualisa 25mm pinch grip shower head holder - grey/chrome (910314)?Carefully remove the wall plate which will be secured using silicone sealant. This will expose the PCB which connect to the control knobs. If you start water flow by pushing a button and the shower has flashing lights, this will be one of our Digital / Smart range. Hello, the angle adjusts via a rather tight ratchet, you need to use the leverage of the head in place to help with adjustment. A rather square, chunky replacement for its sleek Aqualisa predecessor that is now unavailable. Does the job it is supposed to do, only time will tell if it lasts more than 13 years like its predecessor.

Providing the supply pipes are rear fed, all models have 65mm inlet centres. If surface pipework is required, the centres will need adjusting to 65mm for both top or bottom entry. The foot print on the MK3 also differs from the MK1 / MK2 so an extra inch of clearance will be required to ensure this fits and new fixing holes will need drilling. Exposed control (rail through ceiling) / pre 2007 concealed models - Push the control upwards, and the retaining ring will move to release the control from its lower securing lugs. Please note: our Thermostatic and Digital products are not designed to work on mixed supplies (e.g. mains cold / gravity hot) or combination cylinders due to inadequate cold water capacity and working head distance. If the leak is coming from the shower head in the form a constant drip, this is likely due to the hot o'ring being incorrectly positioned, damaged or not renewed. These models have had 2 different designs of valve body during their production as well as solid brass bodies. The hot o'ring is installed differently with each design... You will need to establish firstly whether the dripping is constant or if it stops over time. The easiest way to do this is to remove the head and hose from the shower or in the case of fixed heads, remove the head from the arm.Good fit, and very rapid delivery. Seems to be a design fault within the item, however, as they always fail at the same location after about two years. Very helpful staff assisted me in identifying the part I needed. Product arrived as and when promised A1 service Remove the data cable from the Smart Valve. To do this, the lid must be removed by loosening the single screw between the 2 lids of the Smart Valve (image below). The data cable can be removed by pushing on the lever that secures the cable plug into the Logic Module. Please note: If you are changing from a single adjustable head and wish to now include a fixed head, this will not be compatible with exposed pipework.