Ner Nstrike Elite Rapidstrike CS18

Product Information

Instead you can easily see how many shots your have left without even ejecting the clip from the blaster. It features compatibility with barrel extensions; due to the barrel extension connector being a separate piece of plastic from the main barrel, it can loosen up, resulting in loose fitted barrel extension. Around the time of the blaster's release, the official Nerf page on Facebook boasted that the RapidStrike could unload its clip in 5. Removing it is mandatory particularly for HvZ players and is key to seeing the RS's potential for remarkable reliability in actual use.

While the blaster is more likely to jam, when it does not, it launches darts over a truly elite distance of 90 feet! Route flywheel power wire through FCG clips and solder to NO terminal of the flywheel switch, which is the nice new micro you just installed. The next likely issue is that when wiring the trigger switch, you switched the positions of the positive battery wire (white in my images) and the wire to the cycle control switch (black). I am looking to swap my motors do you have any recommendations that would work with this battery http://www.To make this blaster even more battle ready, the Nerf N-Strike Elite Rapidstrike features not one, but FIVE separate tactical rails! The only difference is how the flywheel cage's negative connection is handled and where the battery leads go. Despite this, and like other re-released Elite XD blasters, it features the same performance as its original counterpart.

Nerfz supports our readers with thousands of hours of reporting and testing to help you find Nerfvana. Not only is there plenty of attachment points (tactical rails) there are also tons of built in features! Pistol configs have placed the battery above the pusher gearbox and used side mount battery boxes in the past.By accepting all cookies, you agree to our use of cookies to deliver and maintain our services and site, improve the quality of Reddit, personalize Reddit content and advertising, and measure the effectiveness of advertising.

Slightly older than the Hyperfire having been released in 2013, the Rapidstrike is still a motorized blaster powered by several batteries. Same goes for other types of batteries with inadequate current capability, such as alkalines, and some types of low-discharge-rate NiCd/NiMH and Li-ion/LiPo packs out of electronics, lights, etc. In any case, make sure the switch is wired to brake the motor when the bolt is retracted and power (or coast, for dead center) when the bolt is extended. The RapidStrike CS-18 is a Nerf blaster that was released on September 1 [2], 2013 under the N-Strike Elite series. Read more about how to modify your Hyperfire in this article: Nerf Hyperfire Modding Guide: The best mods for your hyperfire?As its name suggests, the Elite XD RapidStrike claims to feature improved " Elite XD" internals, which boosts its overall firing power.

If you are currently considering purchasing the Nerf Hyperfire or Rapidstrike, it is not hard to tell that these blasters have more differences than they have in common. To avoid excessive and unnecessary wire, we will bring the negative battery lead in from the battery box, strip 2 spots of insulation, and connect to the negative terminals of the flywheel motors to provide them a ground. Finally, this is a guide for how to deal with the basic electrical work, resulting in the most "vanilla" possible RS build. It was re-released in 2014 with improved Elite XD internals and a white, blue, grey, and orange color scheme; this re-release was shown off at the 2014 New York Toy Fair. If you hold down the trigger without releasing it, the whole clip will empty in a few short seconds.These 4 bosses in the left half of the RS receiver need to be removed; the bottom two ground smooth and flush.