About this deal
Not all camera models generate ONVIF push events for all event types, some binary sensors might, therefore, only be polled. To ensure you have the best latency possible, refer to the Reducing latency of motion events section. Asterisk (*) next to entities listed in this documentation E1 pro, e1 pro PTZ, E1 Zoom, Other, RCL-520, reolink: rlc-410-5mp, RLC 423, RLC 482A, rlc-410-5mp, RLC-423, RLC-510A, RLC-520-5mp, rlc-522, RLC-810A, RLC-811A, rlc-820a, RLC-823a, RLC-842A, Video Doorbell PoE However I discovered that the sound and audio were gradually drifting out of sync - up to about 4 seconds apart. The video is lagging behind the audio. This means that not only is the recording out of sync but also the snapshot starts to miss the event due to the video lagging. If I disable and re-enable the camera in SSS it is all great again but then the drift starts again. If an entity listed below has an asterisk (*) next to its name, it means it is disabled by default. To use such an entity, you must enable the entity first. Number entities
Then power up the camera while pointing it at the QR code. It takes about a minute to initialize, read the QR code, and connect to your Wi-Fi. Showing the camera in the dashboard To make the camera work, you need to use the PoE Switch (IEEE 802.3af, 48V Active) or DC Power (DC 12V1 /2A) to power on the camera. In some camera models, there is a delay of up to 5 seconds between the turn-off command and the sound stopping. The siren turn-on service supports setting a volume and a duration (no turn-off service call is needed in that case). Switch entitiesUnfortunately this does not always shows the latest available firmware (also not in the Reolink applications). Argus Eco, E1 Outdoor, E1 Pro, e1 pro PTZ, RC410, RCL-410, RCL-810A, reolink: rlc-410-5mp, rlc 410w, rlc-410-5mp, rlc-411ws, RLC-423, RLC-510A, RLC-511, RLC-520, RLC-520-5mp, rlc-522, rlc-810a, RLN16-410
However, these cameras can work with this integration through an NVR in which the NVR is connected to Home Assistant. This integration creates a few camera entities, one for each stream type with different resolutions: Main, Sub, Ext, Snapshots Main, and Snapshots Sub. If you fail to add Reolink cameras to Synology, please follow the below steps to make troubleshoot.You may power on Reolink PoE cameras via PoE injector/switch or PoE NVR directly, or by using the power adapter. ONVIF push will result in slightly faster state changes of the binary motion/AI event sensors than ONVIF long polling.