Joined in 2023 
82 
63 About this deal
Update 15 April 2019: One risk point is that if you leave the dongle in the charging position, but disconnect the charger (for example for transport) . The dongle is active all the time and the battery may be empty when you start playing. Another handy little feature on the transmitter of the WL-50 is that there’s a tiny on/off button that’s depressed when plugged into a guitar input. This means that it’s only active when plugged into a guitar, so you don’t get that nasty pop when you take the transmitter out, as you would do with most traditional cables. It can be powered via 9V adaptor or 2 AA batteries for up to 10 hours. If you’re using an adaptor, the WL-50 can be used as a power distribution hub to power other pedals via daisy chain. The WL-50 is designed for players who want to integrate their wireless system into their pedalboard. You may have noticed that the receiver shares a similar size and form factor with the iconic BOSS compact pedal!
A WL-20 system is literally as simple to use as a standard guitar cable. The small transmitter plugs into your instrument, while a matching receiver plugs into a pedal or amp. That’s it! Automatic Wireless Setup To charge the transmitter, the receiver must be powered via a BOSS PSA-S adaptor. It’s also possible to directly charge the transmitter with a standard USB adaptor (5 V/500 mA or higher). WL-20 also features built-in cable tone emulation, which reproduces the tone of using a 10 foot guitar cable. Supplied from the DC IN 5 V port Current Draw 350mA Battery charging time Approximately 3 hours Expected battery life under continuous use Approximately 12 hours
Wireless Freedom for Pedalboards
You can use any of the three (the WL-20, WL-20L, or WL-50), but we recommend the WL-50, which lets you switch the CABLE TONE feature. Have you always dreamed about going wireless with your instrument, but were put off by the complicated setup, tone loss, and bulky adds-ons? If so, the WL-20 series is for you! Driven by new lightning-fast BOSS tech, these ultra-compact music tools deliver premium sound and plug-and-play operation that completely eliminates all the hassles normally associated with wireless systems. Boss says that you’ll get 10 hours playtime out of it, and whilst we’ve not tested the full 10 hours out, we gave it a good play through for a few hours and it remained green the whole time.
The stompbox-sized receivereven contains a DC output to distribute power to connected pedals and keep your signal strong throughout your pedalboard.Move up to 50 metres away from the transmitter all the while perfect tone and get that groove onduring the show completely cable-free.I bought this because the WL-20 and the WL-20-L were not available. I do not regret it! I use it at home and in the rehearsal room, to get rid of the guitar cable. I was fed up getting my feet caught every time in the cable - now with the WL-50 it feels so good. Instead of the little dongle on the amp side (WL-20), I have now the small WL-50 box (even if I do not use a pedal board) standing at the side of the amp, with a 1 m cable to connect the box to the amp. To recall: the "Input" connector is only used when you connect the guitar by cable and do not use the wireless. When the receiver is powered via a BOSS PSA-S adaptor, it becomes a power distribution center for other stomps on your board. By using an optional PCS-20A daisy-chain cable, you’re able to power a number of BOSS compact pedals at the same time. Battery-Powered Operation for Mobile Gigging
May vary due to local conditions) Latency 2.3 ms Dynamic Range 110 dB or greater Frequency Response 20 Hz--20 kHz Nominal Output Level -10 dBu Output Impedance 1 k ohm Recommended Load Impedance 10 k ohms or greater Indicators POWER For information on the CABLE TONE feature, refer to this (the "WL-50: What kind of benefits does CABLE TONE provide?" link). Environmental conditions may affect the actual number of simultaneous systems available. Just Another Pedal on Your BoardCause: The electrical wiring has special specifications, and so the no operation is possible without below remedy. The auto-pairing feature on the WL-20 and WL-50 is really handy for plug and play, but for some users looking to utilise multiple units in their band, it can be easier to know specifically which channel each player is on. The easiest introduction to the world of wireless systems, WL-20 consists of a bug style transmitter and corresponding receiver, with a nominal operating range of 15m. hours charging time will give you 12 hours of battery life for the transmitter, and 10 hours for the receiver. To charge the internal rechargeable batteries, once again it’s as easy as plugging the transmitter and receiver together and connecting a USB cable to charge both at the same time.
Great Deal 
New Comment