Joined in 2023 
82 
63 About this deal
The warranty is not applicable if the product has been subject to physical abuse, improper installation, modification or repair by unauthorized third party. Items not including hoverboards, hoverkarts, and electric scooters will be shipped using the EVRI delivery service. Locate the 2 holes on each footrest: a large hole on the end that will slip onto the kart frame, and a small hole for the screw that is inside the curve on one side. Any other further claims are excluded, especially those for replacement due to damage caused to the outside of the product, provided there is no obligatory legal liability.
When seated on the kart with both feet positioned on the footrests, riders should have a slight bend in the knees. Shorten or lengthen the kart, if necessary, to accommodate the size of the rider. Remove the charger from the hoverboard’s charging port and wall outlet. Replace the cover on the hoverboard charging port. YOU EXPRESSLY UNDERSTAND AND AGREE THAT, TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, HOVER-1'S TOTAL LIABILITY IN CONNECTION WITH THE APPLICABLE HOVER-1 PRODUCTS OR THIS WARRANTY POLICY WILL NOT EXCEED THE AMOUNT YOU ACTUALLY PAID FOR THE PRODUCT. The warranty is voided if repairs or modifications are performed without the written consent of Hover-1 or if our products are equipped with additional parts or accessories that are not approved for the Hover-1. Using any charger, other than a genuine Hover-1 charger, or a charger for a different model, voids the warranty and is a serious fire hazard. Exposure to water, moisture, mud, dirt or debris, voids the warranty.
Readying your hoverboard
Goods outside 30 calendar days shall be issued with a replacement or repair only depending on the warranty length of the product. Troubleshooting: If after inserting the screw into your footrest, you cannot toggle the footrest at all, you have likely inserted the screw without the two holes properly aligned. Remove the screw, realign the holes, and re-insert the screw.
Save 1 washer and 1 bolt in a safe place in case you ever need them; those are spares. Slip 1 washer onto each of the 4 remaining bolts.If necessary, re-level the hoverboard footpads so that they are even and parallel to the floor, and so that the kart handles are positioned upwards on the diagonal.
This warranty gives you specific legal rights, and you may also have other rights which vary under local laws. The following conditions comprise the requirements and scope of our warranty conditions and do not affect our legal and contractual warranty obligations. Grab the nose cap and bag with 4 small screws (labeled “C1”) from your hardware supply. Set 1 screw aside with your other spare hardware; you’ll only need 3 here. The manufacturer will not take any responsibility if the failure of the unit has resulted from accident, abuse, misuse, or any unauthorized repair, modification or disassembly. With the kart still upside down, carefully lift the front of the kart and slide the nose cap underneath such that the nose cap:
Important things to note
From your collection of hardware, look for the 5 washers and 5 large metal bolts. (Not the largest plastic ones; you’ll use those later.) Never recalibrate your hoverboard while standing on it or when it is attached to the kart. A recalibration should always happen without any added weight on the hoverboard.
Great Deal 
New Comment