Armeg G150B4SCH 150mm SDS Plus Scutch Comb Chisel

Product Information

Prior to using chisels, please ensure your machine has the ‘chisel only’ function as they are designed to be used on this function only. The pneumatic scutch chisel is simply pushed into the SDS plus drill to attach it, and then pushed down and out to release it. Lubrication must be re-applied before re-using. Products can fail on the shank due to temperature build up of 200°C. SDS Plus shanks should be greased prior to and during use. This reduces heat build-up which reduces wear on the chisel and on the machine A pneumatic scutch chisel has an added length at one end to enable attachment to an SDS plus drill.

A hammer headed scutch chisel is the most common type of scutch chisel available. It has a flat head and is for use with hammers. A mallet headed scutch chisel has a mallet head for use with nylon/wooden mallets. It is shaped this way to spread the blow over a greater surface area which minimises the damage to the mallet. Prior to using chisel, please ensure your machine has the 'chisel only' function as they are designed to be used on this function only Misuse of the product will decrease the maximum time usage significantly. Shank failure due to temperature build up is not warranted. If the chisel shank has not been hardened, a hammer will splinter the chisel with the force exerted. If it has been hardened, the shank will bend slightly rather than splinter and break.The mallet headed scutch chisel is different to the hammer headed because the shank isn’t hardened. This means it will fracture or chip if it is hit with a hammer, hence why a mallet is more suitable.