5 Litre ROOF Bitumen Primer

Product Information

The integrity and effectiveness of subsequent layers depends on the quality of the first priming. The surface is cleaned of debris, in the rainy season remove moisture from the roof. A bitumen-based primer will harden and adhere to a wet roof, but it is better if there is less free moisture. Cleaning touches the snow, ice. This specification covers asphaltic primer suitable for use with asphalt in roofing, dampproofing, and waterproofing below or above ground level, for application to concrete, masonry, metal, and asphalt surfaces. If the pollution happened recently and the soil has not frozen, you can do without chemistry. It is necessary to remove the substance with a scraper, then rinse with soapy water. You can use a thinner white spirit, gasoline. There are special varieties for different materials, the composition is selected taking into account the adhesion of the upper layers of the surfaces to be joined. Roofing

IKOpro Self-Adhesive Bitumen Primer - IKO Ireland IKOpro Self-Adhesive Bitumen Primer - IKO Ireland

If on the old roof there was roofing material with fine-grained dressing, up to 1 kg of soil will go per square. Reduce consumption by thoroughly cleaning the surface of the roof or walls from dust and dirt. The layer of debris absorbs the agent, therefore the penetration depth decreases and the consumption increases. Preparation for use Emulsion the solution is distinguished by a low degree of ignition; it is used near sources of open fire. Apply by brush or roller. Using a brush, scrub the primer into the surface. Ensure that only a thin coat is applied and that there is no pooling. Priming should extend at least 75mm beyond the area to be waterproofed. Leave to dry for 2­-3 hours before continuing with further work. bitumen is melted in a container with a blowtorch or on a furnace until it turns into a liquid state;

molten resin is mixed into a container with gasoline in small portions (if you add it immediately, the gasoline will ignite); ASTM D41, 2005 Edition, February 1, 2005 – Standard Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing There are no other inclusions or inhomogeneous impurities; toxic substances, for example, toluene, are not used for manufacturing. When processing a roof made of reinforced concrete slabs, the surface of the elements is treated and the butt joints between the panels are impregnated. The subsequent layer of mastic is also placed in the seams, therefore, using a primer, they provide adhesion of materials in a hard-to-reach place. Road

Safety Data Sheet - Bond It

For roofing use bituminous and emulsion-bituminous primers. Impregnation is applied directly to the prepared base to strengthen the top layer. During the drying process, the particles push moisture out of the pores and fill the gaps. After hardening, the plane of the slope does not absorb moisture, it is ready for applying mastic and gluing a reinforcing mesh.The soil is applied in any weather, limitation for use is surface moisture more than 15%. It is difficult to apply the solution on vertical walls and other planes, since it flows down.