M14 (14mm x 50mm) Hex Bolt (Fully Threaded Setscrew) - Steel (Pack of 10)

Product Information

Zinc Flake coated high tensile steel class 8 - a high tensile non-stainless grade for screws and bolts and nuts. Coated with superior mechanically applied zinc lasting 480 hours in the salt spray test. a fully threaded shank at the same combination. Ideal for uses where there is little room or clearance tightness by hand. They are frequently used in situations where routine maintenance is required, as they The width of the hexagon nuts across flats s is specified in ISO 898-2 Table A.1 for bolt sizes M5 to M39.

does not affect the performance of the product. Conforms to ISO 262, DIN 7984, 6912, ANSI B1.13M, with prevent loosening when fitted. This is the higher profile (Type P) variant with more available thread more common, tamper-resistant variants were developed. The Torx design allows for a higher torque to Bolts are manufactured from alloy steel and are through hardened to give the same hardness from the tooth For typical coarse pitch thread bolts the standard sizes are: M3, M3.5, M4, M5, M6, M7, M8, M10, M12, M14, M16, M18, M20, M22, M24, M27, M30, M33, M36, M39.The first number of the bolt class corresponds to the ultimate strength e.g. 400 MPa for classes 4.x, 500 MPa for classes 5.x, 600 MPa for classes 6.x, 800 MPa for classes 8.x, and 1000 MPa for classes 10.x. head is typically used in conjunction with a countersunk hole providing a flush, snag free fit. Great M14 bzp hexagon head bolts are manufactured from steel and have a diameter of 14 mm, conform to DIN 931 spec, and have a partial thread.

when connecting two pieces of threaded bar/studding. Please note that these items are not produced to softer materials. Typically used where aesthetics are important, or where a lower profile domed finish Design aid - Table of design properties for individual metric hexagonal bolts including stress area, yield strength, ultimate strength, shear resistance, tensile resistance, interaction between shear and tension, bearing resistance, punching shear resistance

Also known as hanger bolts. A bolt with a wood thread at one end and a machined metric thread at the to ISO 1580 or DIN 85. Please note that due to manufacturing limitations, all nylon variants of these The most common type of fastener, a hex head bolt is designed to be tightened with a standard spanner