Oatey 30372 No. 95 Tinning Flux, Lead Free 8-Ounce

Product Information

If you plan on cutting and soldering a lot of pipes, you might benefit from a specialised pipe cleaner. Proper heating ensures that the soldering iron tip reaches the right temperature for effective tinning. As you heat the joint, when it gets hot enough, the flux will "flash" silver as the fine solder particles in the flux melt.

Let’s take a look at how flux works to protect your pipes and some of the differences between standard flux and tinning flux to see which one is the best. To produce a smooth, shiny surface, the electroplated sheet is then briefly heated above the melting point of tin. Oatey® H-20® 95 Water Soluble Tinning Flux is a water-flushable flux containing solder powder to aid in the soldering process. The cross-section of the bar needed to be accurate in size as this dictates the length and thickness of the final plates. It meets Bellcore and IPC requirements for No-Clean Classification and provides long-term reliability in manual and automated processes.

Superior SSF-NC50 is a VOC-free, No-Clean flux that promotes the rapid activity necessary for selective soldering. SSF-RMA20 has the controlled activity of an RMA flux, but contains the ideal amount of solvents to reduce the clogging of the flux sprayer nozzle typical with rosin-based fluxes. It is most often used to prevent rust, but is also commonly applied to the ends of stranded wire used as electrical conductors to prevent oxidation (which increases electrical resistance), and to keep them from fraying or unraveling when used in various wire connectors like twist-ons, binding posts, or terminal blocks, where stray strands can cause a short circuit.

This article’s information points to tinning as the most cost-effective and best option for coating wires on the market. This flux is active, cleaning off the oxides and residues from the soldering nozzle, but since it does not contain Chlorides, it leaves a cleaner residue than fluxes that do contain Chlorides. By following these steps regularly, you can keep your tinned soldering iron in excellent condition and ensure optimal performance for all your soldering projects.In testing, the amount of solder used without gaps and the cleanness of the soldering edge affected the lifespan of the copper roof seams.

Once the tip is covered and has a shiny appearance, you can wipe away any excess on the same damp sponge. Tinning the surface of things that you are soldering is standard practice and means adding the melted tin material to the surface of the tip, contact area, and wires you are working on. It's easier to reach around the back side of the pipe if you bend a small hook in the solder wire before you begin soldering. Move the solder and soldering iron together along the bare portion of the wire, melting the solder as you go.Hold a soldering iron to the pipe, or use a blowtorch to heat the metal up until the soldering flux melts into the joint and begins to bubble slightly.