AEM 5-275 Black 2.75" x 3" Silicone Hose

Product Information

Converting from decimals to fractions is straightforward. It does, however, require the understanding that each decimal place to the right of the decimal point represents a power of 10; the first decimal place being 10 1, the second 10 2, the third 10 3, and so on. Simply determine what power of 10 the decimal extends to, use that power of 10 as the denominator, enter each number to the right of the decimal point as the numerator, and simplify. For example, looking at the number 0.1234, the number 4 is in the fourth decimal place, which constitutes 10 4, or 10,000. This would make the fraction 1234

Critical clearances, motorcycle compatibility and stability, load-bearing capacity, speed rating, radial vs. non-radial, pattern and tread compound requirements, inflation recommendations, and front-to-rear tire matching will all vary with tire selection. the decimal would then be 0.05, and so on. Beyond this, converting fractions into decimals requires the operation of long division. multiplied by 100 to give you a whole number for the tire. So instead of .9 the tire is stamped 90.Fraction subtraction is essentially the same as fraction addition. A common denominator is required for the operation to occur. Refer to the addition section as well as the equations below for clarification. a The above tire size conversion chart does not mean that these tires are universally interchangeable. They are to give you a point of reference when upgrading your older tires. Consult your motorcycle’s manual or manufacturer’s customer service TL is a descriptive abbreviation. {See the sections below for more info.} It indicates that the tire is meant for a tubeless application. The majority of modern motorcycles use tubeless tires. If your bike has wire spoke wheels you need to use a tire designed for use with a tube inside. All those spokes and nipples are not air tight. The majority of modern motorcycles and dirt bikes do not use these tires. These were standard equipment on older machines. The Inch or Standard Inch Size Format does not include an aspect ratio. The aspect ratio on these tires is 100. Meaning the section width and section height are equal.

The section width and rim size are defined in the same manner as described for the Alpha and Metric size formats. Proceed right to left. Multiply the ones digit of the bottom number to the next digit to the left in the top number. If you carried a digit, add it to the result and write the answer below the equals line. If you need to carry again, do so.Long multiplication with decimals using the standard algorithm has a few simple additional rules to follow. Also, inch size format tires are all bias type. They do not come in radial. The size will will use for this example is 4.60x17H 4PR. You may also see this written as 4.60H-17 4PR. 4.60