PipeSnug - Waste Pipe Collar and Seal, Grey 40mm (1 1/2") (Pack of 3)

Product Information

A big moment was when FlueSnug was endorsed by the major boiler manufacturers, including Worcester Bosch and Ideal Heating,” continues Alex. PipeSnug simply fits into the hole drilled for the pipework and comes in 32mm, 40mm or 110mm sizes, removing any need for pointing. Its big brother, FlueSnug, can be installed in less than five seconds and snuggly fits the 152mm core-drilled hole in the wall through which the boiler pipe and flue exits. The product can be used both inside and outside the property for the best finish and prevents heat escaping and acts as a barrier to drafts, damp, insects and pests. Sealing around a boiler flue traditionally requires pointing with sand and cement. Removing any need for pointing, FlueSnug can be installed in less than five seconds and snuggly fits the 152mm core-drilled hole in the wall through which the boiler pipe and flue exits. FlueSnug can be used both inside and outside the property for the best finish and prevents heat escaping and acts as a barrier to drafts, damp, insects and pests. Housebuilders must also submit photographic evidence of compliance to its Local Building Control body and energy assessors, and PipeSnug is a very simple and effective way of supplying this evidence. How we helped the Daly Group

The move to Talon is the right one for PipeSnug – Talon will help accelerate the “‘Snug” family of products’ growth through increased distribution, next day delivery, more product development and even more marketing support. The use of pipe collars is being recommended for any type of installation to existing dwellings too, so extensions and loft conversions could also benefit from the use of PipeSnug and FlueSnug for compliance with Building Regulations for pipes in walls. The collars can be used both inside and outside the property for the best finish, they prevent heat loss and act as a barrier to drafts, damp, insects and pests.Another added benefit of the 110mm PipeSnug and the FlueSnug is that they can be installed at height, without the need for ladders or scaffolding. That is because the products are flexible enough to be pushed through the hole meant for the pipework, saving even more time and fuss. Watch a How To video on installing at height here. Where to find out more about Part L Building Regulations PipeSnug is the industry’s only comprehensive solution that meets Part L’s new requirements to seal pipes both inside and out, without the need for sealant, mortar or costly air sealing tape. PipeSnug meets the new Part L building requirements , which now requires pipe seals and grommets to be used around pipework. PipeSnug is the only all-in-one solution which meets Part L’s requirement to seal around pipework inside and out, without the need for sealant, mortar or expensive air sealing tape. We are delighted to announce that we have agreed an exclusive worldwide licensing deal with Talon, the leading manufacturer of pipe clips, collars and covers in the UK.

The new regulations will aim to help the country meet its Net Zero goals by increasing energy efficiency and air tightness in buildings and establishing a minimum requirement for air permeability in new homes. Why PipeSnug is the best solution Chris Burdet and Alex Lever talked about how the product was created and how it has evolved over time in an interview with PHPI. Here is a snapshot of some of the topics that were discussed in the interview. Part L Building Regulations now requires pipe grommets and pipe collars to be used on all service penetrations to help maintain air tightness around pipes in walls.

The market for pipe seals will continue to grow as PipeSnug is the only one that provides an all-in-one solution that meets these criteria. It took about 12 to 18 months for Pipesnug to be launched, during which time there were frequent changes made so that the product met the required quality standard.