Xavax Y Connector for Drain Hose (17mm inner diameter)

Product Information

Insert the hybrid drain hose into the drain Y-connector between the 2 washer drain hoses up to the tape mark. In this special case where you have a hybrid dryer, it is necessary to connect the dryer drain hose. Then connect the long hose from the dryer kit to the other side of the Y-connector and tighten firmly. Please read through the instructions or watch this video in its entirety before attempting installation and be sure to pause the video when necessary. A newer version of this kit will include a drain Y-connector with a 1 inch hose stopper built-in to prevent the hose from being inserted too far.

The main washer cold inlet hose and connect it to the cold water faucets Y-connector and tighten both firmly. Mount the main washing machine using all 16 screws, 4 on each side of the unit using a Philips screwdriver. Adjust the 4 main washing machine feet down about 1/2 turn to tighten them against the pedestal for stability. Caution! Failure to use the clamps could result in flooding if the hoses come loose from the Y-connector.

Similar products